Bunn CW APS Operating Guide

Page 17

P1129

Location:

The limit thermostat is located inside the rear of

the hood on the tank lid.

Test Procedures:
1. Disconnect the brewer from the power source.
2. Disconnect the blue and black wires from the limit

thermostat.

3. With an ohmmeter, check for continuity across the

limit thermostat terminals.

If continuity is present as described, the limit
thermostat is operating properly.
If continuity is not present as described, replace the
limit thermostat.

Removal and Replacement:
1. Remove all wires from limit thermostat terminals.
2. Carefully slide the limit thermostat out from under

the retaining clip and remove limit thermostat.

3. Carefully slide the new limit thermostat into the

retaining clip.

4. Refer to Fig. 5 when reconnecting the wires.

P1800

P1127.40

BLK to Tank
Heater Switch

BLU to BLU Lead from
Control Thermostat

10690 062300

FIG. 3 CONTROL THERMOSTAT TERMINALS

FIG. 4 LIMIT THERMOSTAT

FIG. 5 LIMIT THERMOSTAT TERMINALS

Removal and Replacement:
1. Remove wires from control thermostat leads.
2. Remove the thermostat capillary bulb by firmly

pulling up on the capillary at the tank lid. This will
disengage the grommet from the tank lid.

3. Early Models: Remove the two #8-32 screws se-

curing control thermostat bracket mounted inside
the hood.
Late Models: Remove the one #8-32 screw secur-
ing the control thermostat to the component bracket
in the trunk.

4. Slide the grommet to the line 4.5" above the bulb

on the new capillary tube.

5. Insert the capillary bulb through the hole in the

tank lid and press the grommet firmly and evenly
so that the groove in the grommet fits into the tank
lid.

6. Carefully bend the capillary tube so that the tube

and bulb inside the tank are in the vertical position.

NOTE -  The capillary tube must be clear of any electri-

cal termination and not kinked.

7. Early Models: Using two #8-32 screws secure the

control thermostat inside the hood.
Late Models. Using one #8-32 screw secure the
control thermostat to the component bracket in-
side the trunk.

8. Refer to Fig. 3 when reconnecting the wires.
9. Adjust the control thermostat as required.

BLU to BLU Wire from Limit Ther-
mostat

BLK to BLK Wire from Tank Heater
(Brewers W/Out Faucet)
BLK to Thermal Cut-Off from  Tank
Heater (Brewers with Faucet)