Bunn CW APS Operating Guide

Page 26

P1136

10690 062300

If voltage is present as described, the brew timer is
operating properly. Reset the timer dial as required,
to obtain the desired brew volume.
If voltage is not present as described, replace the
timer.

Removal and Replacement:
1. Separate all connectors between the brewer wir-

ing harness and the timer.

2. Remove the one #8-32 screw securing timer to

component bracket.

3

Install new timer circuit board as described in 

Late

Model Timer section on the following pages.

4. Refer to Fig. 19 when reconnecting the wires.
5. Install the Timer Setting decal, provided with the

replacement timer kit, below the schematic on the
inside of the front access panel.

6. Adjust the timer as required. Refer to 

Late Model

Timer section on the following pages.

To Main Wiring Harness

WHI to Solenoid Valve

BLK to Solenoid Valve

FIG. 17 TIMER TERMINALS

OLD STYLE