Bunn 10 Cup Pourover Coffee Brewer A10 User Manual

13

The water in your Bunn

®

 Coffee Brewer should be emptied whenever it is taken 

on a trip, shipped, or stored in an unheated location with a chance of freezing.

P2084

P2082

1)  Unplug the brewer and cool the hot water in the tank. 

Place the empty decanter on the warmer. Simply pour a 

full water pitcher of cold water into the top of the brewer, 

close the lid and wait for the water to stop flowing from

the funnel. Empty the decanter, repeat. This will cool the 

water in the tank.

2)  Remove sprayhead by turning counterclockwise with your 

fingertips and set it aside.

3)  Grasp the back of the brewer and quickly turn it upside 

down over a sink as shown. Most of the water in the tank 

will flow from the sprayhead opening but some water may

flow from the area around the top lid. Continue tipping

the brewer until the flow of water ceases.

4)  Reinstall the sprayhead when all water has drained from 

the brewer. Securely tighten it by turning clockwise.

Your Bunn

®

 Pour-Omatic

®

 Coffee Brewer is designed to operate in most areas 

of the country. For high altitude use, over 5000 feet, the model A10-D should be 

used.

For service (whether or not warranty is still in effect), drain the brewer, carefully 

pack it so it is fully protected against breakage and send it to one of the authorized 

Bunn-O-Matic facilities listed below:

43422.1 010311