Bunn 10 Cup Pourover Coffee Brewer A10 User Manual

GENERAL INFORMATION

NOTE - THE BREWER IS NOT READY TO PLUG IN

Improper installation will result in permanent damage and void the war-

ranty. Read & follow the instructions on the next page.

• Be certain the tank is full of water before plugging in the brewer. (Requires at

least three quarts to fill).

• This brewer is designed to remain plugged in at all times (except during initial

installation or when cleaning.)

• A power switch is provided on the lower left side to completely shut off all elec-

trical components when your plans take you away from home for several days.

Safety features, designed into the Bunn

Pour-Omatic

coffee brewer, make the

daily use of this switch unnecessary.

• Whenever the brewer has been shut off or unplugged, allow the water in the tank

to heat to the proper temperature before using (about fifteen minutes or until the

heating sound stops).

• Your Bunn

Pour-Omatic

coffee brewer has a specially designed tank to keep

the water at the proper temperature. This constant supply of hot water assures

the correct method of brewing coffee, in less than three minutes.

• The brewed coffee flows into the decanter where it is kept at serving temperature

on the porcelain decanter warmer. The warmer is controlled by the lighted on/off

switch on the front of the brewer.

NOTE - The warmer switch only controls the decanter warmer.

• While coffee is being brewed, the newest water in the tank is heated to the proper

temperature and held until needed.

• The decanter lid reduces coffee evaporation and temperature loss.

• Hot water, approximately 50˚ F hotter than that available from your hot water

faucet, is always available for other uses.

• This brewer has an attached, polarized cordset and requires 2-wire grounded

service rated 120 volts ac, 120 amps, single phase, 60 Hz. Do not attempt to

bypass the safety aspect of this polarized plug.

• The sprayhead will periodically become loose. Using extreme caution not to burn

yourself, retighten the sprayhead with your finger tips.

NOTE - A severe burn may result if the sprayhead becomes loose and

falls off while brewing.

43422.1 010311