Bionaire BWM2601 Leaflet

Page of 2
15.NEVER tilt, move, or attempt to empty unit while it is
operating. Shut off and unplug before removing the
water reservoir and moving the unit.
16.This humidifier requires daily and weekly maintenance
to operate appropriately. Refer to daily and weekly
cleaning procedures. Use only cleaners and additives
recommended by the manufacturer.
17.NEVER use detergents, gasoline, glass cleaner, 
furniture polish, paint thinner, or other household 
solvents to clean any part of the humidifier.
18.Excessive humidity in a room can cause water 
condensation on windows and some furniture. If this
happens, turn the humidifier OFF.
19.Do not use humidifier in an area where humidity level is
in excess of 50%. Use a hygrometer, available at your
local hardware store or through Bionaire, to measure
the humidity.
20.DO NOT attempt to repair or adjust any electrical or
mechanical functions on this unit. Doing so will void
your warranty. The inside of the unit contains no user
serviceable parts. All servicing should be performed by
qualified personnel only.
21.Never place humidifier housing under water flow or
immerse in liquids.
22.Do not plug in the cord with wet hands: electric shock
could result.
23.Do not pour water in any openings other than the
water tank.
24.To prevent damage to surfaces, do not place humidifier
under overhanging surfaces.
25.NEVER operate unit without water in the tank.
26.Use both hands when carrying full tank of water.
PLEASE SAVE THESE
INSTRUCTIONS
CONSUMER SAFETY INFORMATION
This appliance has a POLARIZED AC
PLUG (one blade is wider than the
other). To reduce the risk of electric
shock, this plug is intended to fit in a
polarized outlet only one way. If the plug
does not fit fully in the outlet, reverse the
plug. If it still does not fit, contact a
qualified electrician to install the proper outlet. 
DO NOT ATTEMPT TO MODIFY THIS PLUG OR
DEFEAT THIS SAFETY FEATURE IN ANY WAY.
The length of cord used on this appliance was selected to
reduce the hazards of becoming tangled in, or tripping
over a longer cord. If a longer cord is necessary an
OPERATING INSTRUCTIONS
1.  Plug the power cord into a 120V AC electrical outlet.
2. Turn the Mode Knob to the High position ( 
II ). The
Power Light will be On and the Refill Light will be Off. It
is normal for the humidifier to take about 10 minutes to
warm up and begin to mist.
3. After the unit begins misting, set the humidifier to the
desired power setting [High ( 
II ) or Low ( )].
RESET PROCEDURE
NOTE: When the water tank is empty and the water in the
heating chamber is almost empty, the Automatic Shut Off
will activate. The Refill Light will illuminate and the unit will
not operate again until you refill the water tank and reset
the humidifier.
1.  Turn the Mode Knob to off (
O
).
2.  Unplug the unit.
3.  Remove and refill the water tank, being sure to follow
the Daily Maintenance Instructions. Replace the tank
onto the base.
approved extension cord may be used. The electrical
rating of the extension cord must be equal to or greater
than the rating of the humidifier (refer to rating artwork
placed on the humidifier). Care must be taken to arrange
the extension cord so that it will not drape over the
countertop or tabletop where it can be pulled on by
children or accidentally tripped over.
HOW YOUR WARM MOISTURE HUMIDIFIER WORKS
Your Bionaire
®
Warm Moisture humidifier is designed to
allow the proper amounts of water to flow out of the tank.
Air is drawn in through the grill openings and mixed with
steam in the misting chamber.  The warm mist is then
dispersed out of the top of the misting chamber through
the outlet grill and into the room. Warm moisture
humidifiers put moisture back into the air you breathe to
help relieve sinus and respiratory discomforts, reduce
annoying static electricity and provide a healthy growing
environment for your indoor plants.
PRE-OPERATING INSTRUCTIONS
1.  Be sure the humidifier is switched off and disconnected
from the electrical outlet.
2.  Select a location for your humidifier, on a flat surface,
about 4 inches (10 cm) away from the wall. Do not
place your humidifier on furniture, a floor location that
will not be damaged by moisture is best.
3.  Remove the water tank by holding the tank handle and
lifting straight upwards.
FILLING THE WATER TANK
1. Twist off the water tank cap located on the bottom of
the water tank by turning counter clockwise and fill the
water tank with cool fresh water. Do not fill with warm
water as this may cause leaking.
2. After filling the water tank, replace the water tank cap
by firmly turning clockwise and then replace the water
tank onto the base. The water tank will immediately
begin to empty into the base.
DAILY MAINTENANCE
Allow to cool before maintenance.
1.  Before cleaning, set the control to off position (
O
) and
unplug the unit from the electrical outlet. 
2.  Remove the water tank then unlock the misting 
chamber by rotating the safety lock towards the front of
the unit. Lift mist chamber from the unit’s base. Now 
lift the tray from the base.
3.  Empty water and minerals from the tray and place in 
the top rack of the dishwasher. This will remove any
sediment and dirt that has accumulated in the tray. 
NOTE: It is imperative that the tray is cleaned properly.  
The tray is dishwasher safe (top rack ONLY) for easy 
cleaning.  
4. Wipe the heating element clean with a soft cloth 
after it has had a chance to cool.
5. Replace misting chamber and engage safety lock.
The Electronic Thermal Control Heating element is 
provided with a special coating that is designed to provide
the easiest cleaning and prolong the operating efficiency of 
the humidifier. DO NOT use any metal or hard objects to 
clean the Heating Element. Never use detergents, gasoline,
kerosene, glass cleaner, furniture polish, paint thinner or
other household solvents to clean any part of the humidifier.
WEEKLY MAINTENANCE
Remove scale: Allow to cool before maintenance.
1.  Repeat steps 1-5 in the Daily Maintenance section.
2.  Clean the tray by partially filling the tray with one 8-oz
cup of undiluted white vinegar.  Let solution stand 20
minutes, cleaning all interior surfaces with a soft brush.
Dampen a cloth with undiluted white vinegar and wipe
out entire tray to remove scale.
3.  Rinse with clean warm water to remove scale and the
white vinegar solution before beginning to disinfect the
tank.
4.  Wipe the heating element clean with a soft cloth after 
it has had a chance to cool. 
Water Tray
Control Panel
Fig 1
Humidifier
Housing
Tank Handle
Water Tank
Safety Lock Tab
4. Wait 20 minutes for Automatic Shut-Off to reset. 
5. After 20 minutes, plug in the unit and turn the Mode
Knob to High. The Refill Light should now be off (if not
repeat steps 1 through 5). In about 10 minutes, the
humidifier will begin to produce moisture.
If the Refill Light is still on at this point, and the unit does
not begin to product moisture within a few minutes, then
repeat Steps 1-5.
IMPORTANT: If you do not plan to use the humidifier for
two or more days, make sure any residual water is drained
from the water tank and base to prevent algae or bacteria
growth.
WARM MIST CLEANING AND MAINTENANCE
INSTRUCTIONS
The following maintenance procedures must be 
routinely followed in order to ensure proper, 
efficient operation of your humidifier. The unit may not
operate properly without following the cleaning and
maintenance instructions. 
When the unit is in use, daily and weekly maintenance is 
recommended. Regular weekly cleaning prevents scale
buildup on the heating element and tray.  It also prevents
micro-organisms from growing on the tray and tank. This
ensures that maximum efficiency will be achieved.  
The manufacturer cannot over-emphasize how essential
proper cleaning is to the maintenance and continued use
of your unit and to the avoidance of algae or bacteria
build-up. 
Mode Knob
Refill Light
Fig 2
Power Light
HUMIDIFIER SAFETY 
PLEASE READ AND SAVE 
THESE IMPORTANT 
SAFEGUARDS
When using electrical appliances, basic safety precautions
should always be followed to reduce the risk of fire, electric
shock, and injury to persons, including the following:
1. Read all instructions before using the appliance.
2. To avoid fire or shock hazard, plug the appliance 
directly into a 120V AC electrical outlet.
3. Keep the cord out of heavy traffic areas. To avoid fire
hazard, NEVER put the cord under rugs, near heat 
registers, radiator, stoves, or heaters.
4. DO NOT place humidifier near heat sources such as
stoves, radiators, and heaters. Do locate your 
humidifier on an inside wall near an electrical outlet. The
humidifier should be at least 4 inches (10 cm) away
from the wall for best results.
5. NEVER place humidifier in an area where it is accessible
to children. NEVER use humidifier in a closed room,
particularly where a child may be sleeping, resting, or
playing (a closed room may result in excessive humidity).
6. WARNING: Do not attempt to refill humidifier without
first unplugging the unit from its electrical outlet. Failure
to heed this warning may cause personal injury.
7. NEVER place anything over moisture outlet when unit is
running.
8. NEVER drop or insert any object into any openings.
9. DO NOT operate any appliance with a damaged cord
or plug, if the appliance malfunctions, or if it has been
dropped or damaged in any manner. Return appliance
to manufacturer for examination, electrical or
mechanical adjustment, or repair.
10.Use appliance only for intended household use as
described in this manual. Any other use not
recommended by the manufacturer may cause fire,
electric shock, or injury to persons. The use of
attachments not recommended or sold by the
manufacturer may cause hazards.
11.DO NOT use outdoors.
12.Always place humidifier on a firm, flat, level surface. (4
inches (10 cm) from wall). A waterproof mat or pad is
recommended for under the humidifier. NEVER place it
on a rug or carpet, or on a finished floor that may be
damaged by exposure to water or moisture.
13.DO NOT allow the moisture outlet to directly face the wall.
Moisture could cause damage, particularly to wallpaper.
14.Humidifier should be unplugged when not in use.
BWM2601_08EM2.qxd  5/29/08  9:22 AM  Page 2