Behringer Europack UB1204FX-Pro Owner's Manual

EURORACK UB1204FX-PRO/UB1204-PRO User Manual

The packaging of your mixing console contains two 19" rack mount wings which 

can be installed on the side panels of the console.
Before you can attach the rack mount wings to the mixing console, you need to 

remove the screws holding the left and right side panels. Use these screws to 

fasten the two wings onto the console, being careful to note that each wing fits 

a specific side. With the rack mount wings installed, you can mount the mixing 

console in a commercially available 19" rack. Be sure to allow for proper air flow 

around the unit, and do not place the mixing console close to radiators or power 

amps, so as to avoid overheating.

You will need a large number of cables for the various connections to and from 

the console. The illustrations below show the wiring of these cables. Be sure to 

use only high-grade cables.

The footswitch connects both poles momentarily

Fig. 4.1: 1/4" TS connector for foot switch

4.2.1  Audio connections
Please use commercial RCA cables to wire the 2-track inputs and outputs.
You can, of course, also connect unbalanced devices to the balanced 

input/outputs. Use either mono plugs, or ensure that ring and sleeve are bridged 

inside the stereo plug (or pins 1 & 3 in the case of XLR connectors).

For unbalanced use, pin 1 and pin 3 

have to be bridged

1 = ground/shield

2 = hot (+ve)

3 = cold (-ve)

1

2

3

1

2

3

Fig. 4.2: XLR connections

Fig. 4.3: 1/4" TS connector