Westinghouse 14 SEER, 95% AFUE R8HE Gas/Electric Packaged Unit Technical Manual
• Copeland Scroll Compressor: State of the art compressor is standard
equipment.
• Micro-Channel Coils: Both indoor and outdoor all aluminum coils
are designed to optimize heat transfer, minimize size and cost, and
increase durability and reliability.
increase durability and reliability.
• Wire guard coated with earth friendly epoxy and plastic mesh
hail guard: A guard that will never rust and protects the units coil
from being damaged.
from being damaged.
• Easy Compressor and Control Access: Designed to make servicing
easier for the contractor, access panels are provided to all controls
and the compressor from the side of the unit. Easy access to the
evaporator coil for cleaning and general maintenance.
and the compressor from the side of the unit. Easy access to the
evaporator coil for cleaning and general maintenance.
• Permanently Lubricated Condenser Motor: A heavy duty PSC motor
for long lasting reliability and quiet operation. Requires no maintenance
and is completely protected from rain and snow.
and is completely protected from rain and snow.
• Thermostatic Expansion Valves: Factory installed externally
equalized thermostatic expansion valves provides precise refrigerant
control under varying load conditions.
control under varying load conditions.
• Hi/Low Pressure Switches: Ensure long compressor life.
• Externally Accessible, Service Ports: Quick access to refrigeration
• Externally Accessible, Service Ports: Quick access to refrigeration
system.
• Liquid Line Filter Driers: Factory installed at a convenient location
for service.
• Quiet Operation and Low Vibration: Swept-wing fan blade combined
with custom Venturi condenser fan.
• Two-Stage Heat Operation: Featuring a two stage gas valve, 2 speed
inducer motor, and 2 speed blower control.
• Choice of Heating Control: Two stage thermostat or single stage
heating thermostat with control board timing of a 10 minute delay for
second stage of heat.
second stage of heat.
• Tubular primary heat exchanger: Heavy gauge aluminized steel
heat exchanger.
• Stainless Steel secondary heat exchanger: Assures a long life.
• 100% fired and tested: All units and each component are tested on
• 100% fired and tested: All units and each component are tested on
the manufacturing line.
• 30 second blower delay: At start-up assures a warm duct temperature
at start-up. Adjustable blower off settings (60, 90, 120, and 180 seconds).
• 30 second post purge: Increases life of heat exchanger.
• Hot Surface igniter: Innovative application of an appliance type igniter
• Hot Surface igniter: Innovative application of an appliance type igniter
with a 20 year history of reliability.
• SmartLite® Control Board: Provides extended life to igniters using
hot surface ignition technology. Programmed to learn the heat-up
characteristics of the igniter, then adapt the ignition time to the
characteristics of the furnace so the igniter is energized appropriately.
characteristics of the igniter, then adapt the ignition time to the
characteristics of the furnace so the igniter is energized appropriately.
• LP Convertible: Simple burner orifice and regulator spring change
for ease of convertibility.
• Designed using Galvanized Steel: With a polyester urethane coat
finish. The 950 hour salt spray finish is 1.5 mil thick and resists corrosion
50% better than comparable units.
50% better than comparable units.
• Corrosion-Resistant Drain Pan: Quickly drains away evaporator
condensate.
• Embossed Bottom Pan: Keeps blower component compartment dry.
• Smaller Panels, Great Fit and Finish, Total Seal: Well-designed,
• Smaller Panels, Great Fit and Finish, Total Seal: Well-designed,
quality construction.
• One Piece Top Pan: With drip edge on top panels whisks away rainwater.
• Low Voltage Transformer: Includes 5 Amp fuse to protect low voltage
• Low Voltage Transformer: Includes 5 Amp fuse to protect low voltage
circuit.
• Energy Efficient Brushless DC Blower Motor: ECM constant torque
in all models.
• Horizontal Air Delivery: To accommodate ground mount horizontal
applications.
• Heavy-Gauge, Full Perimeter Base Rails: Facilitates forklift handling
and curb mounting.
• Removable Top Grille Assembly: Allows ease of service to the fan motor.
• Duct Flanges: Reduce installation costs.
• Proven, Industry Standard Components: Easier service and
• Duct Flanges: Reduce installation costs.
• Proven, Industry Standard Components: Easier service and
availability.
R8HE Series Rev A
95% AFUE Condensing Heat
Exchanger offering Two-Stage Heating
and 14 SEER Single-Stage Cooling
with ECM Blower
Exchanger offering Two-Stage Heating
and 14 SEER Single-Stage Cooling
with ECM Blower
These single packaged gas/electrics are high efficiency
self-contained heating and cooling units that can be
installed at ground level on a slab. The unit design makes
installations simple in all applications. Units are ETL and
ETLc listed.
self-contained heating and cooling units that can be
installed at ground level on a slab. The unit design makes
installations simple in all applications. Units are ETL and
ETLc listed.
TECHNICAL
SPECIFICATIONS
SPECIFICATIONS
FEATURES and BENEFITS
Click or scan with your
smart phone to view
a video with drain kit
instructions for rooftop
installations.
smart phone to view
a video with drain kit
instructions for rooftop
installations.
Single-Phase