Bunn Water Dispenser HW2A User Manual

USER NOTICES

The notices on this dispenser should be kept in good condition. Replace unreadable or damaged labels.

10052 042409

00657.0000

00831.0000

WARNING

Fill water tank before turning - on -

thermostat or connecting appliance

to power source.

Use only on a properly protected

circuit capable of the rated load.

Electrically ground the chassis.

Follow national/local electrical codes.

Do not use near combustibles.

FAILURE TO COMPLY RISKS EQUIPMENT

DAMAGE, FIRE, OR SHOCK HAZARD

READ THE ENTIRE OPERATING MANUAL

BEFORE BUYING OR USING THIS PRODUCT

THIS APPLIANCE IS HEATED WHENEVER

CONNECTED TO A POWER SOURCE

37881.0000

This equipment must be installed to comply

with the International Plumbing Code of the

International Code Council and the Food

Code Manual of the Food and Drug Adminis-

tration (FDA). For models installed outside

the U.S.A., comply with the applicable

Plumbing /Sanitation Code.

00656.0000

12593.0000

CE REQUIREMENTS

• This appliance must be installed in locations where it can be overseen by trained personnel.

• For proper operation, this appliance must be installed where the temperature is between 5°C to 35°C.

• Appliance shall not be tilted more than 10° for safe operation.

• An electrician must provide electrical service as specified in conformance with all local and national codes.

• This appliance must not be cleaned by water jet.

• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental

capabilities, or lack of experience and knowledge, unless they have been given instructions concerning use of

this appliance by a person responsible for its safety.

• Children should be supervised to ensure they do not play with the appliance.

• If the power cord is ever damaged, it must be replaced by the manufacturer or authorized service personnel with

a special cord available from the manufacturer or its authorized service personnel in order to avoid a hazard.