Weil-McLain Therma Trim Electric Baseboard Heater Leaflet
Position back panels
Back panels must be positioned correctly to accommodate accessories, as shown below.
Hinged
end cap
Inside
bay corner
Outside
corner
Splice
Inside
corner
Plain end cap
or wall end
Min 3 ¾"
Max 4 ½"
Min 1
Z\v
"
Max 1
>|zn
"
Min 0"
Max 2
Z|x
"
Butt back panels together.
Min 3"
Max 3
Z\v
"
T
HERMA
T
RIM
MODEL TT HYDRONIC BASEBOARD
ASSEMBLY INSTRUCTIONS
Attach back panel to wall
Screw or nail into wall
studs at top and bottom.
studs at top and bottom.
No closer than 3 inches
from end of panel.
from end of panel.
Bottom of panel must
never be lower than the
surface of the finished
floor or carpet.
Add shim as shown if
necessary.
never be lower than the
surface of the finished
floor or carpet.
Add shim as shown if
necessary.
Shim (if needed)
Finished floor surface
or carpeting.
or carpeting.
Install brackets
Position brackets evenly along length of
panel, approximately every 2 feet.
panel, approximately every 2 feet.
Insert top bracket tab
into top slot in back
panel.
into top slot in back
panel.
Press bracket flat
against back panel
and slide down so
bottom tab enters
bottom slot in back
panel.
against back panel
and slide down so
bottom tab enters
bottom slot in back
panel.
a
b
New
length
Cut element
When a shorter length is needed
Measure from the
female end for the
required length.
female end for the
required length.
Cut copper using
tube cutter and
ream to remove
burrs.
tube cutter and
ream to remove
burrs.
New
length
a
Remove 6 fins on
each side of the
location to be cut.
each side of the
location to be cut.
c
Cut glide rails with
tin snips.
tin snips.
b
d
550-110-762/0400