Wayne-Dalton 255081 Leaflet

Components:
(1) pair End Bracket Extension
(1) TorqueMaster

™

 Center Bracket Extension

(1) TorqueMaster

™

 Adjustable Center Bracket

(4) 1/4” - 14 x 5/8” Self Tapping Screws
(2) 3/8” - 16 x 3/4” Truss Bolt
(2) 3/8” - 16 Hex Nut
(2) 1/4” - 20 x 9/16 Track Bolts
(2) 1/4” - 20 Hex Head Nuts

Use this insert in conjunction with the installation manual provided with the door.  Follow the corresponding steps in this insert with the steps in the 
installation manual.

255081

          REV1     02/19/2010

Prior to securing the vertical track assemblies to the jamb as detailed 
in the product specific installation instruction manual, first secure the 
end bracket extensions to the 12” radius TorqueMaster

™

 flagangles.  

Locate the left and right end bracket extensions with the left and right 
flagangles.  Align and insert the Twistlock

™

 tab in the end bracket ex-

tension with the butterfly hole in the appropriate flagangle and rotate 
1/4 turn to lock into place (Figure 1).  Secure the end bracket exten-
sion to the flag angle using (1) 3/8 -16 x 3/4” truss bolt and hex nut.

Before installing the adjustable center bracket, the bushing must be 
removed from the standard center bracket. First twist strait arm on 
both the standard and adjustable center brackets so that the bush-
ing may pass through.  After pulling the bushing from the standard 
center bracket, place it into the adjustable center bracket and twist 
the straight arm back to the original position.  Align the center bracket 
extension with the adjustable center bracket and loosely fasten with 
two (2) 1/4” - 20 x 9/16” track bolts and hex nuts (Figure 2).

©Copyright 2010 Wayne-Dalton, a Division of Overhead Door Corporation

Wayne-Dalton, a Division of Overhead 
Door Corporation
P.O. Box 67
Mt. Hope, OH 44660 
www.Wayne-Dalton.com