Sprint Nextel SP-809 User Manual
30
Telephone Operation
Follow these steps to store a number in memory.
1
Press
PROG/MEM
.
2
Enter the number you want to store. (To store the last number
you dialed, simply press
REDIAL
.)
If you enter a wrong digit, press
DELETE
to delete the last
entered digit. Then enter the correct digit.
3
Press
PROG/MEM
then enter a two-digit memory location num-
ber (01–20). The SP-809 beeps three times.
Note: If you receive a call while you are storing information in
memory, press
memory, press
PHONE
to answer the call. After the call, begin
again at Step 1.
To replace a stored number, simply store a new one in its place.
Entering a Pause
In some telephone systems, you must dial an access code (9, for
example) and wait for a second dial tone before you can dial an
outside number. You can store the access code with the phone
number. However, you should also store a pause after the access
code to allow the outside line time to connect. To do so, hold down
the number immediately preceding the pause until you hear a sec-
ond beep. (For example, if 9 is your access code, hold down 9 until
you hear a second beep.) This enters a 1.5-second pause. For a
longer pause, hold down the number key until you hear additional
beeps.
example) and wait for a second dial tone before you can dial an
outside number. You can store the access code with the phone
number. However, you should also store a pause after the access
code to allow the outside line time to connect. To do so, hold down
the number immediately preceding the pause until you hear a sec-
ond beep. (For example, if 9 is your access code, hold down 9 until
you hear a second beep.) This enters a 1.5-second pause. For a
longer pause, hold down the number key until you hear additional
beeps.
PROG/MEM
43-5809.fm Page 30 Wednesday, August 18, 1999 1:43 PM