Room & Board Gallery Media Shelves Assembly Instruction
800.301.9720 | roomandboard.com
5/1/11
assembly instructions: gallery
List of parts
2 – side frames
5 – shelves
1 – wire management panel
5 – shelves
1 – wire management panel
Hardware
6 – sharp, self-drilling screws
20 – screws
14 – plastic bumpers
20 – screws
14 – plastic bumpers
Tools needed
Phillips screwdriver
Directions
1. Lay out the two side rails on a soft, flat surface. Note which side rail is right and which is
left. Attached steel shelf-mounting brackets should all face inward on both rails.
2. Start with right side of rail and attach largest shelf (19" deep) to first steel bracket
mounted just above leg. Make sure cut-outs on shelf are facing toward the back. Insert
screws into underside of shelf bracket and then up into pre-drilled holes on right side of
shelf. Tighten using a Phillips screwdriver (Figure 1).
screws into underside of shelf bracket and then up into pre-drilled holes on right side of
shelf. Tighten using a Phillips screwdriver (Figure 1).
3. Continue adding progressively smaller shelves to right side rail until all five are attached
with the smallest shelf on top (Figure 2).
4. Repeat steps 2 and 3 with left side rail (Figure 3).
5. Turn unit over so shelf cut-outs are facing up (Figure 4).
6. Attach the wire management panel vertically into shelf cut-outs using sharp, self-drilling
screws (Figure 5). Make sure top of wire management panel is flush with third shelf from
bottom (A). Tighten screws with Phillips screwdriver.
bottom (A). Tighten screws with Phillips screwdriver.
7. Place a plastic bumper in each corner on back of every shelf. In addition, place two
bumpers at top back of each side rail pole for extra wall protection.
8. Tip unit upright next to wall moving unit around slightly so top of frame, or top shelf,
touches the wall first (Figure 6).
MADE IN
Wisconsin
MADE IN
Wisconsin