Yard Works Yardworks 60-1620-4 Owner's Manual

NOTE: The units illustrated may vary slightly from your 
unit. 
1.  Remove any packing material which may be between 

upper and lower handles. 
a. 

Pull up and back on the upper handle to raise the 
handle from position A into the operating position. 
See Figure 3-1.

b.  Tighten hand knobs

 

securing upper handle to 

lower handle. Make sure that each carriage bolt is 
seated properly in the handle.

2.  Place one carriage bolt (found in the hardware pack 

included with your unit) in the upper hole of the right 
handle mounting bracket from the inside outward. See 
Figure 3-2. Secure with one 

wing nut

. Repeat process 

on the left side.

3.  Rope guide Setup as follows, see Figure 3-3:

a.  Hold the blade control against the upper handle. 

Position A.

b.  Slowly pull starter rope out of engine. Position B.
c.  Slip starter rope into the rope guide. Position C.
d.  Tighten rope guide wing nut .Position D.

4.  Insert post on cable tie into hole provided on the lower 

handle. Pull cable tie tight and trim excess. See Figure 
3-4.

5. 

Ea

ch wheel has a height adjustment lever to change 

the cutting height of the mower. To change the height 
of cut, squeeze adjuster lever toward the wheel, 
moving up or down to selected height. See Figure 3-5.