StorageTek Host Software Component 6 User Manual

1st ed., 6/30/04 - 312579601

specifies that a volume report is to be produced. 

optionally specifies that a report is to be produced for only a particular ACS. 

The one or two digit hexadecimal ACS identifier. 

optionally specifies that a report is to be produced for only certain LSMs within an 
ACS. 

lsm-list indicates the LSMs. An lsm-list can be a single LSMid or a list of 
LSMids. An LSMid (lsm-id) is made up of the ACSid (hexadecimal 00-FF) and 
the LSM number (hexadecimal 00-17) separated by a colon (:).  

An LSM range is not allowed. If a list is specified, the elements must be 
separated by blanks or commas, and the entire list enclosed in parentheses. 

optionally specifies that the report only contain information on certain VOLSERs. 

volser, vol-range, and vol-list indicate the volume serial numbers requested. 
Any subranges of volumes specified in the vol-list that are not in the control 
data set are listed in the Control Card Image Listing portion of the report using 
one line per subrange. 

A percent sign (‘‘%’’) may be used as a ‘‘wildcard’’ character in the VOLSER 
to specify pattern matching. The percent sign designates that any single 
character can match the corresponding position in the VOLSER. 

For example, A9%%%% specifies that all of the six-character volume serial 
numbers that begin with the characters ‘‘A9’’ are selected for the report. 

Q%12% specifies that all five-character VOLSERs that begin with ‘‘Q’’ and 
have a ‘‘12’’ in the third and fourth positions of the VOLSER are selected for 
the report. The percent sign cannot be specified in a range specification. 
Therefore, ‘‘A%0000-A%9999’’ is invalid. 

In the Volume Report Listing of the utility, the volumes requested which are not 
in the control data set are not listed.