Sterling Welder 882.01749.00 User Manual

882.01749.00  

12 

of 

93 

 

6.  EXTRUSION – “Simple”:  Connect the input cable (2-conductor cable-gray) to a dry 

  contact 

signal that indicates the extruder 

  screw is turning. (

The connection in the controller should 

  be on terminal block #10 and PLC input X5..  A jumper wire 

  can also be installed on the same terminals (instead of a dry 

  contact.) if the feeder is to be started and stopped through the    

 feeder controller, and not with the extruder screw. 

 

7.   EXTRUSION – “Follower”:  Connect the input cable (2-conductor cable-gray) to a  

0-10 VDC, 0-20 mA, or 4-20 mA signal from the extruder 

that indicates the screw speed (rpm) of the extruder.

 (The  

    connection inside the controller should be on terminals blocks   

     51and  54.        

Touch the ACS logo on the main menu screen to access the configuration menu. See section # for 
details. 

 
 

Select injection molding (default value). 

Enter nominal motor speed.