Sterling Welder 882.01749.00 User Manual

882.01749.00 

 

7 of 93 

 

 

These regulations should be read, understood and periodically reviewed by all personnel 
involved in any way with this machine. 

Never operate or remove any machine components that are secured by wrench-type fasteners 
unless the motor is electrically locked out and the disc is motionless. 

Never operate the machine unless the dosing module is in place and all guards and covers are 
in place and secure.  

Prior to clearing a jam or performing any maintenance, the motor should be turned off and 
electrically locked out. Be sure that the disc has stopped. Hands must not be inserted into the 
machine to clear the jam. 

Never extend fingers through safety guards. 

Be sure that the v-belts are properly aligned and that tension is at its maximum. 

Extreme care should be taken to see that all bolts are properly tightened at all times.  

This machine is designed for the feeding of free-flowing granular materials. Do not feed any 
other materials into the machine without consulting with one of our Application Engineers.   

These machines are constructed for maximum operator safety when used under standard 
operating conditions and when recommended instructions are followed in the maintenance 
and operation of the machine. 

All personnel engaged in the use of the machine should become familiar with its operation as 
described in this manual. 

Proper operation of the machine promotes safety for the operator and all workers in its 
vicinity. 

Becoming familiar with materials, inspection, speed limitations, screens, and guard 
maintenance and total user responsibility will assist you in learning potential areas in need of 
observation for danger. 

Each individual must take responsibility for observing the prescribed safety rules as outlined.  
All caution, warning and danger signs must be observed and obeyed. All actual or potential 
danger areas must be reported to your immediate supervisor.