Shop-Vac Oxygen Equipment XPO100 User Manual
SECTION 2—COMPONENT REPLACEMENT
XPO
2
™
12
Part No 1150748
4. Transfer the
5
/
8
-inch tubing to the intake of the new filter.
NOTE: The flow arrow points away from the intake.
5. Connect the 11½- inch tubing to the outlet of the inlet filter (Detail “A” of FIGURE 2.4).
6. Position and orient the new filter in the holder (Detail “B” of FIGURE 2.3).
7. Re-assemble the XPO
5. Connect the 11½- inch tubing to the outlet of the inlet filter (Detail “A” of FIGURE 2.4).
6. Position and orient the new filter in the holder (Detail “B” of FIGURE 2.3).
7. Re-assemble the XPO
2
. Refer to Re-assembling the XPO
2
on page 13.
Replacing the Battery
CAUTION
Before handling the P.C. board, ensure you are properly grounded to prevent static
damage to the components of the board. A static cuff MUST be worn and properly
grounded using an alligator clip. Electrical conduit or a water pipe is normally sufficient
when a known good ground in unavailable. Care should be taken to ensure that the
alligator clip contacts a bare metal surface.
NOTE: For this procedure, refer to FIGURE 2.5.
1. Perform the steps in Accessing XPO
1. Perform the steps in Accessing XPO
2
on page 9.
2. Remove the inlet filter with tubing attached from the holder.
3. Disconnect the battery wiring harness from the PC board.
4. Remove the battery from the thermal pad and battery tray.
NOTE: The thermal pad is between the battery and the bottom of the tray. It is a soft “dough-like”
3. Disconnect the battery wiring harness from the PC board.
4. Remove the battery from the thermal pad and battery tray.
NOTE: The thermal pad is between the battery and the bottom of the tray. It is a soft “dough-like”
material that adheres to the tray. If thermal pad is damaged or pulled up during battery removal it
MUST be replaced.
FIGURE 2.5 Replacing the Battery
Tubing
Inlet Filter
Battery Wiring Harness
connects here
Battery
PC Board