SBE HighWire HW400c/2 User Manual
HighWire HW400c/2 User Reference Guide Rev 1.0
4.2.25 SPI Error and Status Register (SESR)
The SPI Error Register is a Read Only register. SBSY clears when the previous
operation is completed, and the SPIFER, RACKER, and BYTER error flags clear
when the next operation is started.
operation is completed, and the SPIFER, RACKER, and BYTER error flags clear
when the next operation is started.
PIFER, RACKER and BYTER are valid after SBSY=0 (Interface Ready), but are
T
Bit 7
Bit 6
Bit 5
Bit 4
Bit 3
Bit 2
Bit 1
Bit 0
SBSY can be polled immediately after writing to the RBC or WBC registers.
S
cleared when writing to the RBC or WBC registers for the next operation.
able 55. SPI Error and Status Register (SESR) Offset Address 0x1F
Reser
BSY
ved Reserved Reserved Reserved
BYTER RACKER SPIFER S
SB
SPI Interface ready for re
e ope
SPI Interface busy; oper
rogr
PI
R
= 0
SPIF Check passed
= 1
SPIF Check failed; no operation performed
Byte count was OK
4.2.26 EEPROM
ddress
(EAR)
he EEPRO Addres Register is a Read/Write register. It is used for selecting the
16-
ord)
M.
ster (EAR) Offset Address 0x28
Bit 7
SY
= 0
ad/writ
ration
= 1
ation in p
ess
S FE
= 0
RACK Check passed
RACKER
= 1
RACK Check failed; no operation performed
= 0
BYTER
= 1
Byte count was zero; no operation performed
A
Register
T
M
s
desired (
bit w
address when accessing the serial EEPRO
Table 56. EEPROM Address Regi
Bit 6
Bit 5
Bit 4
Bit 3
Bit 2
Bit 1
Bit 0
EAR7 EAR6 EAR5 EAR4 EAR3 EAR2 EAR1 EAR0
EAR[7:0]
= 0x00 – 0xFF
(Word Address)
October 10, 2006
Copyright 2006, SBE, Inc.
Page
61