Porter-Cable HR1364 User Manual

Congratulations on your purchase and welcome to Philips! To fully benefit 

from the support that Philips offers, register your product at www.philips.

com/welcome.

A

  Normal speed button

B

  Turbo speed button

C

  Motor unit

D

  Blender bar

E

  Whisk coupling unit (HR1364/HR1362 only)

F

  Whisk (HR1364/HR1362 only)

G

  Chopper coupling unit (HR1364/HR1363 only)

H

  Chopper blade unit (HR1364/HR1363 only)

I

  Chopper bowl (HR1364/HR1363 only)

J

  Beaker

Read this user manual carefully before you use the appliance and save it for 

future reference.

 - Never immerse the motor unit in water or any other liquid, nor rinse it 

under the tap. Only use a moist cloth to clean the motor unit.
Warning

 - Check if the voltage indicated on the appliance corresponds to the local 

mains voltage before you connect the appliance.

 - Do not use the appliance if the plug, the mains cord or other parts are 

damaged.

 - If the mains cord is damaged, you must have it replaced by Philips, a 

service centre authorised by Philips or similarly qualified persons in 

order to avoid a hazard.

 - Never let the appliance run unattended.

 - This appliance is not intended for use by persons (including children) 

with reduced physical, sensory or mental capabilities, or lack of 

experience and knowledge, unless they have been given supervision or 

instruction concerning use of the appliance by a person responsible for 

their safety.

 - Children should be supervised to ensure that they do not play with the 

appliance.

 - Do not touch the blades, especially when the appliance is plugged in. 

The blades are very sharp.

 - If the blades get stuck, unplug the appliance before you remove the 

ingredients that block the blades.
Caution

 - Switch off the appliance and disconnect it from the mains before you 

change accessories or approach parts that move during use.

 - This appliance is intended for household use only.

 - Do not exceed the quantities and processing times indicated in the 

table.

 - Do not process more than three batches without interruption. Let 

the appliance cool down to room temperature before you continue 

processing.
Electromagnetic fields (EMF)

This Philips appliance complies with all standards regarding electromagnetic 

fields (EMF). If handled properly and according to the instructions in this 

user manual, the appliance is safe to use based on scientific evidence 

available today.

This appliance is equipped with overheat protection. If the appliance 

overheats, it switches off automatically. Unplug the appliance and let it cool 

down for 5 minutes. Then put the mains plug back into the wall socket 

and switch on the appliance again. Please contact your Philips dealer or an 

authorised Philips service centre if the overheat protection is activated too 

often.

Thoroughly clean the parts that will come into contact with food before 

you use the appliance for the first time (see chapter ‘Cleaning’).

  1 

Mount the holder vertically to the wall as shown in the figure. Use

suitable screws and plastic wall plugs to mount the holder (Fig. 2).

Do not mount the holder above or near a radiator, an oven, a cooker or

a sink.

  2 

Attach the blender bar to the motor unit (‘click’). (Fig. 3)

  3 

Place the hand blender in the holder. Then wind up the cord and place

it in the cord storage compartment. (Fig. 4)
Preparing for use

  1 

Let hot ingredients cool down before chopping them or pouring

them into the beaker (max. temperature 80 °C).

  2 

Cut large ingredients into pieces of approximately 2 cm before

processing them.

  3 

Assemble the appliance properly before plugging it into the wall

socket.
Using the appliance
Hand blender

The hand blender is intended for:

 - blending fluids, e.g. dairy products, sauces, fruit juices, soups, mixed 

drinks and shakes.

 - mixing soft ingredients, e.g. pancake batter or mayonnaise.

 - pureeing cooked ingredients, e.g. for making baby food.

  1 

Attach the blender bar to the motor unit (‘click’) (Fig. 3).

  2 

Immerse the blade guard completely in the ingredients (Fig. 5).

  3 

Switch the appliance on by pressing the normal or turbo speed

button.

  4 

Blend the ingredients by moving the appliance slowly up and down

and in circles (Fig. 6).
Chopper (HR1364/1363 only)

The chopper is intended for chopping ingredients such as nuts, meat, onions, 

hard cheese, boiled eggs, garlic, herbs, dry bread etc.
The blades are very sharp! Be very careful when handling the blade unit,

especially when removing it from the chopper bowl, when emptying the

chopper bowl and during cleaning.

  1 

Put the chopper blade unit in the chopper bowl (Fig. 7).

  2 

Put the ingredients in the chopper bowl.

  3 

Put the coupling unit onto the chopper bowl (Fig. 8).

  4 

Fasten the motor unit onto the chopper bowl (‘click’) (Fig. 9).

  5 

Switch the appliance on by pressing the normal or turbo speed

button.

 

, If the ingredients stick to the wall of the chopper bowl, loosen them

by adding liquid or using a spatula.

 

, Always let the appliance cool down after chopping meat.

The whisk is intended for whipping cream, whisking egg whites, desserts etc.

  1 

Connect the whisk to the coupling unit (Fig. 10).

  2 

Connect the coupling unit to the motor unit (‘click’) (Fig. 11).

  3 

Put the ingredients in a bowl.

  4 

Immerse the whisk completely in the ingredients and to avoid

splashing start processing at normal speed by pressing the normal

speed button. (Fig. 12)

  5 

Continue with turbo speed after approx. 1 minute by pressing the

turbo speed button.
Cleaning

  1 

Unplug the appliance and detach the accessories before cleaning.

  2 

Clean the beaker, the chopping bowl (HR1364/HR1363 only), the

chopper blade unit(HR1364/HR1363 only) and the whisk without

coupling unit (HR1364/HR1362 only) in the dishwasher or in warm

water with some washing-up liquid.

It is recommended to remove the rubber ring from the chopper bowl 

before cleaning.

2

4222.005.0100.2