Pertech 5300 User Manual

Pertech Resources Inc.

November 2005

220321A

After the printer is set up, you can run two print diagnostic reports / tests and

enter the configuration menu. Below is an example of the configuration report.

1 Press and hold the Paper Feed Button and then

press the Power Switch to turn the printer on and

start the first test.

Validation printers will perform a Self Test if a form is

detected, when the power is turned on.

Release the Paper Feed Button after 4 seconds for

the printing to begin.

The 5300 completes a test of RAM , a checksum

test of program memory, homing and maintenance

of the print head, and then prints the configuration

settings.

2 To change the configuration settings, press the

Paper Feed Button when prompted, the Left LED

will begin flashing.

Note: Validation-Only printers do not have this

feature.

Note: If Ink Status Reset is set to “Manual”, first

option to print will be “Press feed to Reset Ink Tally”.

A. Entering the configuration mode, the printer prints

the Set-Up Instructions and prompts the user to

press the feed button to reject the current settings.

B. If you don’t want to change an option, wait for five

seconds and the next option will print.

C. After completing the Configuration Mode, the

printer prints the new configuration settings and

stores them in non-volatile memory.

Note: Exiting setup early by turning the printer off

will erase any changes made to the configuration.

You must complete the setup for changes to take

effect.

Configuration Report & Setup Mode

��

Serial Number:

********

Main Firmware

Revision:

* ** ***

CRC:

****

Boot Firmware

Revision:

* ** ***

CRC:

****

Printer Control Language

PCL:

ACL Language

Diag Mode:

Standard Print

Auto LF:

CR = CR

Soft Fault Recover:

Automatic

Font:

Standard

Font Quality:

Draft

Intl Char set:

USA

Code Page:

437 USA

Receipt LPI:

6 Lines Per Inch

Validation LPI:

6 Lines Per Inch

RS232 Serial (when used)

Baud Rate:

57.6K

Data Bits:

8-bits

Stop Bits:

1-bit

Parity:

None

Flow Control:

Hardware

USB (when used)

Descriptor:

Model Number

Hardware

Validation Clamp:

Closed

Form Insert Wait:

1 Min

Paper Low Sensor

Enabled

Ink Status Reset:

Automatic

Document Stop:

1.75 Inches

Column Alignment

Half Speed:

Full Speed:

Memory

Installed RAM:

128K

Installed ROM:

512K

Total User Flash:

64K

Flash Logos

32K

Flash Fonts

Flash Macros:

Flash Raw Data:

32K

Total User Ram:

24560

Ram Logos:

24560

Ram Fonts:

Ram Macros:

Tallies

Printed Lines:

Dot Count:

Validation Opens:

Feed Distance:

Hours On:

Flash Updates:

Cover Opens:

Diagnostic:

====================================

Press paper feed to change configuration

Press paper feed to enter print test

=================================

Press paper feed to change configuration

SET-UP INSTRUCTIONS

PRESSING THE PAPER FEED BUTTON WHILE THE

GREEN LIGHT IS FLASHING WILL REJECT THE

LAST PRINTED PARAMETER. IF THE BUTTON IS

NOT PRESSED WITHIN 5 SECONDS. THE PARAM-

ETER WILL BE ACCEPTED AND THE NEXT SET-UP

OPTION WILL BE LISTED.

PRESS THE PAPER FEED BUTTON NOW TO

REJECT THE CURRENT CONFIGURATION AND

CONTINUE WITH THE PRINTER SET-UP.

3 Otherwise, wait 10 seconds

and you can choose to enter

an Extended Print Test. After

this test, or Ignoring this

option, will return the printer

to normal operation after 10

seconds.

4. Extended Print Test:Checks the

printers vertical line alignment,

character fonts, and pitches.