Pertech 5300 User Manual

In order to ensure compliance with the Product Safety,  FCC and CE marking requirements. you must use the power supply, 
power cord, and interface cable which were shipped with this product or which meet the following parameters:

Input power to this product must be provided by one of the following:
(1) A NRTL Certified power source with a Limited Power Source
(LPS) output for use in North America, input rated 100 - 240 Vac, 1.5 A, 50/60 Hz, Output rated 24Vdc, 2.5 A Maximum and 
60W Maximum. or  
(2) A power source with a Limited Power Source (LPS) output Certified by an agency recognized in the country of 
installation, input rated 100 - 240 Vac, 1.5 A, 50/60 Hz, Output rated 24Vdc, 2.5 A Maximum and 60W Maximum. Use of this 
product with a power supply other than the Pertech power supply will require you to test this power supply and the Pertech 
printer for FCC and CE mark certification. 

A shielded (360 degree) interface cable must be used with this product. The shield must be connected to the frame or earth 
ground reference at each end of the cable.
 Use of a cable other than the described here will require that you test this cable with the Pertech printer and your system  
for FCC and CE mark certification. 

For North America a NRTL Recognized detachable power cord must be used. For applications where the power supply 
module may be located on the floor, a power cord with Type SJT marking must be used. 
For applications outside of North America, Power cords which meet the country of installation’s certification and application 
requirements must be used.
Use of a power cord other than described here may result in a violation of safety certifications which are in force in the 
country of use.