Perle Systems 5500208-43 User Manual
IOLAN DS1/TS2 CLI Reference Guide, Version 4.3
74
I/O Commands
Chapter 9
9
This chapter defines all the CLI commands associated with configuring the IOLAN’s I/O parameters.
Global I/O Commands
Set IO UDP
Description Sets the UDP settings for I/O unicast messages.
User Level Admin
Syntax
User Level Admin
Syntax
Options
mode
broadcast-interval
entry
You can specify up to four sets of UDP IP address that will receive the I/O unicast.
udp_port
start_ip
end_ip
set io udp [mode on|off]
[broadcast-interval <broadcast_interval>]
set io udp entry 1|2|3|4 disabled
set io udp entry 1|2|3|4 <udp_port> <start_ip> [<end_ip>]
Enables/disables UDP broadcast of I/O channel status (data).
Enter the interval, in seconds, for UDP broadcasts of I/O channel status (data). Valid
values are 1-9999. Default value is 30 seconds.
values are 1-9999. Default value is 30 seconds.
The UDP port that the IOLAN will use to relay messages to servers/hosts.
The first host IP address in the range of IP addresses (for IPV4 or IPV6) that the
IOLAN will listen for messages from and/or send messages to.
The last host IP address in the range of IP addresses (for IPV4, not required for IPV6)
that the IOLAN will listen for messages from and/or send messages to.