PEAK-System Technik PCAN-DONGLE IPEH-002015 User Manual
PCAN-Dongle (ISO) – User Manual
First Test
After turning on the PC the red LED at the PCAN-Dongle must be
permanently on. This indicates that the power supply for the PCAN-
After turning on the PC the red LED at the PCAN-Dongle must be
permanently on. This indicates that the power supply for the PCAN-
Dongle is correct.
Attention! Don't remove PCAN-Dongle from the PC while
powered on (red LED on PCAN-Dongle is lit). Electronic parts of
powered on (red LED on PCAN-Dongle is lit). Electronic parts of
the PCAN-Dongle or the PC's parallel interface may be harmed.
2.2
Connecting a HS-CAN
A CAN is connected to the 9-pin Sub-D port on the PCAN-Dongle.
The pin assignment corresponds to the CiA recommendation DS
The pin assignment corresponds to the CiA recommendation DS
102-1.
Figure 1: Pin assignment HS-CAN
(view onto male connector of the PCAN-Dongle)
2.3
5-Volt Supply at the CAN Connector
A 5-Volt supply can optionally be routed to pin 1 and/or pin 9 of the
CAN connector (PCAN-Dongle ISO: pin 1 only) by setting solder
CAN connector (PCAN-Dongle ISO: pin 1 only) by setting solder
bridges on the PCAN-Dongle PCB (Dongle case opened). Thus
devices with low power consumption (external transceivers or
devices with low power consumption (external transceivers or
optocouplers, for example) can be directly supplied via the CAN
connector.
connector.
7