Toshiba Magnia Z300 User Manual
Installing Software
AFT, ALB and IPSec functions
193
1 Start up “Intel(R)PROSet II” from “Start” - “Settings” - “Con-
trol panel”.
2 Select one LAN adapter to configure AFT/ALB on from the
“Intel(R)PROSet II” adapter list, click the right mouse button,
and select “Create New Team” under “Add Team”.
and select “Create New Team” under “Add Team”.
3 The Teaming Wizard screen is displayed. Select either
“Adapter Fault Tolerance” or “Adaptive Load Balancing”, and
click “Next”.
click “Next”.
4 Mark the checkbox of the LAN adapter to add to the configu-
ration, and click “Next”.
5 Click “Done”.
6 The “member Adapters” icon is displayed in the PROSet II
screen. Among the cards on which AFT/ALB is installed
select a card to set as the primary, click the right mouse button,
and click “Preferred Primary”.
select a card to set as the primary, click the right mouse button,
and click “Preferred Primary”.
7 Click any one of the remaining cards in the PROSet II screen
with the right mouse button, and click “Preferred Secondary”.
NOTE: All cards other than the card that you selected as
“Preferred Primary” are treated as if “Preferred Secondary”
has been selected. However, select “Preferred Secondary”
preferentially for a specific card from among these cards.
“Preferred Primary” are treated as if “Preferred Secondary”
has been selected. However, select “Preferred Secondary”
preferentially for a specific card from among these cards.
8 Click “OK”.
9 The network settings screen is displayed for the team that has
been created. Set the IP address and other network settings for
that team.
that team.
10 Restart the server.
Setting IPSEC (installing Packet Protect)
Set as follows to use IPSEC functions.
1 Make sure that the following conditions are satisfied: