Toshiba Magnia Z300 User Manual
Installing and Removing Hardware
Before starting operation
Before starting operation
50
The installation or removal of an optional device should be
carried out at ambient temperatures of 50 to 95°F (10 to
35°C) for Micro Tower Types, or 50 to 89°F (10 to 32°C) for
Rack Types, and at ambient humidity of 30 to 80%. Avoid a
place where the temperature may change sharply because it
may cause condensation inside the equipment.
carried out at ambient temperatures of 50 to 95°F (10 to
35°C) for Micro Tower Types, or 50 to 89°F (10 to 32°C) for
Rack Types, and at ambient humidity of 30 to 80%. Avoid a
place where the temperature may change sharply because it
may cause condensation inside the equipment.
Don't install/remove an optional device in a static environ-
ment (e.g. on a carpet). Electronic parts easily become defec-
tive if they are exposed to electrostatic discharge.
ment (e.g. on a carpet). Electronic parts easily become defec-
tive if they are exposed to electrostatic discharge.
Proceed with the installing/removing process in the correct
order.
order.
Different types of screws are used or need to be used.
Always restore screws to their original position.
When the system falls into malfunction or failure, consult our
authorized MAGNIA service provider.
authorized MAGNIA service provider.
After installing/removing components, always replace the
server panels before switching the server back on.
server panels before switching the server back on.
When tightening a screw, always use the correct fitting screw-
driver. An incorrect fitting screwdriver may damage the screw
head.
driver. An incorrect fitting screwdriver may damage the screw
head.
Screw head and screwdriver
You may have to remove cable (s), when installing optional
devices. In this case, check the relative position between the
unit and cables before disconnecting the cables for reference.
devices. In this case, check the relative position between the
unit and cables before disconnecting the cables for reference.