TERK Technologies 143P005 Leaflet

TERK Technologies Corp. (TERK) warrants this product against defects in 

materials or workmanship for one (1) year from the date of purchase. 

During this warranty period, this product will be replaced without charge. 

This warranty does not cover any damage due to acts of nature, commercial 

use, accident, misuse, abuse or negligence. This warranty is only valid in 

the USA. Replacement as provided under this warranty is the exclusive remedy 

of the consumer. TERK shall not be liable for any incidental or consequential 

damages for breach of any express or implied warranty on this product, 

except to the extent that limitations of this sort are prohibited by applicable law. 

THERE ARE NO IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS 

FOR A PARTICULAR PURCHASE EXCEPT TO THE EXTENT THAT IMPLIED 

WARRANTIES OF EITHER SORT ARE REQUIRED BY APPLICABLE LAW, AND 

IN SUCH CASE, EACH WARRANTY IS LIMITED IN DURATION TO ONE YEAR.

Take your SIR-Mini (for SIRIUS Satellite Radio) 
or XMicro (for XM Satellite Radio) and place the 
antenna on the top of the bracket between the metal
tab and the cable pass-through hole (Fig.5). 

Route the cable from the antenna through the top 
of the bracket using the cable pass-through hole.  
Determine the best route for the cable to reach the 
satellite radio receiver. 

Note: The cable has a very small diameter and should 
be routed with care.  Three feet of cable protector has 
been included.  Please install the cable protector around 
the cable when going through areas that may cause 
damage to the cable such as a door jamb or window. (Fig.4)

Once the cable has been routed to the satellite radio 
receiver, plug the antenna connector into it.  
Please refer to your satellite radio receiver owner’s 
manual to activate your satellite radio service and 
complete your receiver installation

.

While holding the brackets together, install the lock 
washers and the wing nuts (Fig.3). Before completely 
tightening the wing nuts make sure that the ground 
plane of the bracket where the antenna will be located
is parallel to the ground. Tighten both wing nuts so that 
the bracket is secure.

Select the top bar of either the driver’s side or 
passenger side mirror mount (Fig.1). Place the 
bracket on the front side of the bar (Fig.2).  

Insert the two metal tabs of the small bracket 
into the two slits near the top of the L-bracket 
(Fig.2).

Lower the small bracket over the mirror bar until 
the bolts in the L-bracket come through the 
slots of the small bracket (Fig.2).

 

Works with Magnetic Mount Satellite Radio Antennas
Shown below with the TERK XMicro & SIR-Mini

For more information, visit www.terk.com,
For technical support, call 1.800.942.TERK (8375) 

Made in China

One year limited warranty

The SIRIUS name is a trademark of
SIRIUS Satellite Radio

The XM name is a trademark of
XM Satellite Radio

TERK and TERK Technologies are trademarks of 
TERK Technologies Corp. Commack, NY

©2004 TERK Technologies Corp.

143P005