Konica Minolta BP-200 User Manual
9
Specifying management settings
9-36
200/250/350
Spe
c
if
y
ing
ma
nag
eme
n
t s
e
tti
ng
s
Chap
ter
9
Specifying administrator forwarding settings (mode 198)
You can specify whether a received document is forwarded to a destination
specified by the administrator.
specified by the administrator.
Factory settings
Specifying settings
The shaded cells represent the factory settings. The page numbers on the
right refer to the descriptions of the corresponding functions.
right refer to the descriptions of the corresponding functions.
(*) Bit 7 of mode 198 is enabled only when “1 (transmit)” is specified.
Bit
7 6 5 4 3 2 1 0
Setting
1 1 0 1 0 0 0 0 (HEX: D0)
Bit
Description
Setting
Description
Page Ref-
erence
erence
7
Specifies whether a received
document is forwarded to a
destination specified by the
administrator.
document is forwarded to a
destination specified by the
administrator.
0
Not forwarded
1
Forwarded
6
Specifies whether to enable
TX Forwarding when scan-
ning.(*)
TX Forwarding when scan-
ning.(*)
0
Not forwarded
---------
1
Forwarded
5, 4
Specifies the print condi-
tions of transmission reports
for TX Forwarding.(*)
tions of transmission reports
for TX Forwarding.(*)
00
Not output
---------
01
Undeliverable
10
Always prints
11
*Do not specify these set-
tings.
tings.
3, 2, 1, 0
-----------------------------
0000
*Do not change these bits
when specifying settings for
this function.
when specifying settings for
this function.
---------