John Deere Products & Services Portable Generator DCA70SSJU4i User Manual

Loads can be connected to the generator by various 

methods, output terminal lugs, camlocks or the convenience 

receptacles (Figure 13). Make sure to read the operation 

manual before attempting to connect a load to the generator.
To protect the output terminals from overload, a 3-pole, 

200A 

main circuit breaker is provided. Make sure to switch 

all circuit breakers to the OFF position prior to starting 

the engine.

LOAD

NEUTRAL

GROUND

HARD WIRE

HOOKUP PANEL

LOAD

GFCI

RECEPTACLE

LOAD

CS-6369

TWIST-LOCK

RECEPTACLES

CAMLOCKS

An 

over current relay (Figure 14) is connected to the main 

circuit breaker. In the event of an overload, both the circuit 

breaker and the over current relay may trip. If the circuit 

breaker can not be reset, the 

reset button on the over 

current relay must be pressed. The over current relay is 

located in the control box.

Remember the

 overcurrent relay monitors the current 

flowing from the 

u,v, and W output terminal lugs 

to the load.
In the event of a short circuit or over current condition, 

it will automatically trip the 200 amp main breaker.
To restore power to the 

Output Terminal panel, press 

the reset button on the overcurrent relay and place the 

main circuit breaker in the closed position (ON).