Jensen JHT350 User Manual

Language Video Audio More Aud Rating

TV Shape

TV System

Video Output

4:3 PS

NTSC

S-Video

NTSC

PAL

AUTO

Notes:

Do not direct the remote sensor toward

any light source, such as direct sunlight or

a strong fluorescent light, as it may cause

the unit to not operate correctly.

When other remote controls are used

nearby or when the remote is used near

equipment using infrared rays, interference

may occur.

Placing an object on the remote control

may cause it to inadvertently depress a

button, changing a function and shortening

battery life.

Do not glaze the front of the DVD receiver

with colored glass, as it may cause

interference with normal operation of the

controller.

Make sure there is no barrier between the

remote control and remote sensor, as it

could prevent the unit from receiving the

signal.

Do not spill water or put wet items on the

remote control.

Never disassemble remote control.

BATTERIES

INCORRECT USE OF BATTERIES MAY

CAUSE THEM TO LEAK, CORRODE OR
EXPLODE.

Battery Installation

1. Push down and out on the battery Compart-

ment cover to remove it.

2. Insert the two AAA batteries into the battery

compartment of the remote control, making

sure the + and - signs on the batteries and

inside the battery compartment match up.

3. Replace the battery compartment cover.

Notes:

Do not mix batteries from different manu-

facturers, nor old ones with new.

If the remote control will not be used for an

extended period of time, remove the

batteries to prevent damage-causing

corrosion.

Remove dead batteries immediately to

prevent damage-causing corrosion.

If battery leakage occurs, wipe the battery

liquid from the battery compartment, then

replace both batteries.

Always replace both batteries at the same

time, using new, fully charged batteries.

Life expectancy of batteries may vary

depending on amount of use.

Using the Remote Control
Point the remote control at the remote sensor
on the DVD receiver. When the signal is

received from the remote control, the unit will

function accordingly. The remote will operate to

approximately 16'

from the remote sensor at an

angle of around 30

degrees each direction.

OPERATING THE

REMOTE CONTROL

SYSTEM SETUP

[Video]

the [Video] sub

Select

in the Setup Menu, and press ENTER to display

Video Setup

. Press ENTER to confirm

B. Press SETUP to exit the Setup Menu

Press to change your selection

Press to

select the menu

item

Note: Not all DVDs offer movies in Full Screen format. If not, the disc will override your

TV Display setting and the movie will be displayed in Letterbox format.

set

. Press ENTER

B. Press to return to the Setup Menu

Language Video Audio More Aud Rating

TV Shape

TV System

Video Output

4:3 PS

NTSC

S-Video

[4:3 PS] -Pan and scan refers to pictures where part of pictures is cut
off so it fills the whole screen.
[4:3LB] -Letter Box refers to pictures where black bands appear at the
top and bottom.
[16:9] -The picture fills the screen of a wide-screen (16:9) television.

Select [TV shape], and press ENTER or to display the [TV shape] submenu:

[TV system]

the [TV system] sub

Select

and press ENTER or to display

Press to change your selection

A . Press ENTER to confirm

B. Press SETUP to exit the Setup Menu.

[NTSC] -Select if you are using NTSC signal system to match your TV set.
[PAL] -Select if you are using PAL signal system to match your TV set.
[AUTO]- Select if you are using AUTO signal system to match your TV set.

Language Video Audio More Aud Rating

TV Shape

TV System

Video Output

4:3 PS

4:3 LB

16:9

4:3 PS

NTSC

S-Video