Mitsubishi Electronics Mitsubishi Digital Electronics Video Gaming Accessories FX3G User Manual

890

/FX

3UC

Series Programmable Controllers

Programming Manual - Basic & Applied Instruction Edition

A Programming Tool Applicability and Version Upgrade History

A-1 Programming Tool Applicability

Appendix A-1-4

Cautions on using transparent function by way of USB in GOT1000 Series

Make sure to provide the following setting when monitoring circuits, monitoring device registration and reading/writing
programs in an FX

/FX

3UC

PLC using GX Developer Ver. 8.22Y or later and the transparent function by way of

the USB in the GOT1000 Series.
If the following setting is not provided, a communication error occurs.

Setting in GX Developer (Ver. 8.22Y or later)

1. Select [Online]

→ [Transfer setup...] to open "Transfer setup" dialog box.

2. Double-click [Serial] in [PC side I/F] to open "PC side I/F Serial setting" dialog box.

3. Select "USB (GOT Transparent mode)".

4. Click [OK] button to finish the setting.

GX Developer Ver.8.21X or former

GX Developer Ver8.22Y or later

When using transparent function by way of USB in
GOT1000 Series

Not supported (not available)

Setting shown below is required.

When using transparent function by way of RS-232 in
GOT1000 Series

Set "COM port" and "Transmission
speed" on "PC side I/F Serial setting"
dialog box.

Select "RS-232C" in setting shown
below, and set "COM port" and
"Transmission speed".

When directly connecting GX Developer to PLC
When directly connecting GX Developer to PLC
(standard built-in RS-422 port)

Select "USB (GOT transparent mode)"

Double-click it.

PLC

This example shows a window displayed
when GX Developer Ver. 8.72A is used.

/FX

3CU

PLC

Select "USB (GOT transparent mode)"

Double-click it.

This example shows a window displayed
when GX Developer Ver. 8.72A is used.