Millennium Enterprises A1 User Manual

Page 5

55 – Outboard Barrier in Not Up When the Outboard 

Barrier Latch is Down

56 – Outboard Barrier is Not Latched and trying to go 

down after the hand control button has been re-
leased.  Must reset by pressing the Up button until 
the outboard barrier is latched, then press down 
so the platform goes to the ground level and the 
outboard barrier is deployed

75 – Low Voltage Detected; must turn off power switch 

to reset LCD

77 – Vehicle Secure Interlock has not been activated
99 – Controller Program is not Valid; Replace Controller 

 

Flashing 65 – Unfold button is pressed
Flashing 66 – Fold button is pressed
Flashing 67 – Down button is pressed
Flashing 68 – Up button is pressed
Flashing 69 – Bridge switch is activated
Flashing 70 – Outboard barrier latch switch is activated
Flashing 72 – Outboard barrier up switch is activated
Flashing 73 – Inboard barrier up switch is activated
Flashing 74 – Inboard barrier occupied switch is acti-

vated

Flashing 76 – Outboard barrier occupied switch is 

activated

Flashing 78 – Threshold tape switch “A” is activated
Flashing 79 – Threshold tape switch “B” is activated
Flashing 83 – Tower #1 switch is activated
Flashing 84 – Tower #2 switch is activated
Flashing 85 – Tower #3 switch is activated
Flashing 86 – Tower #4 switch is activated

Listed below are codes that the lift controller outputs 
during lift operation. The codes will be displayed 
on an LCD screen located on the lift control board 
inside the pump module.  See the Manual Operating 
Instructions in the operator's manual for pump cover 
removal instructions.  

 

01 – Platform Stowed
02 – Platform Unfolding
03 – Platform Unfolding Paused
04 – Platform at Floor Level
05 – Platform Beginning to Lower
06 – Platform Lowering (Threshold Cannot Be Occu-

pied from this Point Down)

07 – Outer Barrier Moving to Horizontal Position
08 – Platform at Ground Level
09 – Outer Barrier Moving to Vertical Position
10 – Platform Raising
11 – Platform Raising Paused at Floor
12 – Platform Folding (limited pressure)
13 – Platform Folding (full pressure)
14 – Timed Fold (Cinching Lift Tite) or (Anti-Rattle 

State)

15 – Platform Folding Stopped
28 – Illegal Function/Not Defined
29 – Interlock Fault Not Recognized
30 – Platform Location Unknown
31 – Platform Location Transition State; Attempting to 

Locate Position

50 – Outboard Barrier Is Not Up When Tower 4 LED Is 

Not On

51 – Threshold is Occupied When Tower 2 LED Is Not 

On

52 – Inboard Barrier Is Not Up and Locked When Tower 

1 and Tower 4 LED’s Are On

53 – Inboard Barrier Occupied Sensor Is Not Activated 

When Tower 1 and Tower 2 LED’s Are On

54 – Outboard Barrier is Occupied Before it is Up