LXE HX2 E-EQ-HX2RG-B User Manual

Tapping the Power Key

 

25

 

E-EQ-HX2RG-B 

 

HX2 Reference Guide 

 

The Power key is a round button located above the F4 key. 

When a battery is connected to the HX2 for the first time press the Power key. The mobile device 
begins the startup process. Wait until the Windows CE desktop appears. 

Suspend/Resume Mode -- At other times, tapping the Power key places the HX2 immediately in 
Suspend Mode. Tapping the Power key again immediately returns the HX2 from Suspend.  

See Also:  Sections titled LED Indicators and System Status LED later in this guide.   

•  If installed, RFTerm starts up automatically at the conclusion of each reboot. 
•  If installed and enabled, AppLock runs automatically at the conclusion of each reboot. 
•  If installed and pre-configured, the wireless client connects automatically during each 

reboot.  

•  If installed and pre-configured, Bluetooth re-connects to nearby paired devices 

automatically at the conclusion of each reboot. 

•  If installed and pre-configured, Wavelink Avalanche connects remotely and downloads 

updates automatically during each reboot. 

Press and hold the Power key for approximately 15 seconds until the display blanks, then release 
the key. If user data was not saved before the Hardware Reset function started, data loss occurs 
and  unsaved registry settings are lost.  

User data is saved whenever a Suspend/Resume function is complete. 

Tap 

 | Run and type warmboot. Tap the OK button. A warm boot does not affect the operating 

system, but data and programs in RAM are cleared, and registry changes, if any, are saved. 
Network and Bluetooth connections will need to be re-established.