Lexicon Blu Ray Disc Player BD-30 User Manual

Lexicon

Setting the Remote Code

The remote control supports one of three remote codes. The

default is “Code 1”. If you have other Lexicon products placed

close to the BD-30, they may inadvertently respond to the BD-30

remote control. In this case you can select a different remote code

to avoid conflicts.

To select a new remote code, open the battery compartment cover

of the remote control, and then use a ballpoint pen to flip the

switch to one of the positions marked as “1”, “2”, or “3”. Close

the battery compartment cover. Make sure that the BD-30 player

is turned on and the disc tray is ejected. Aim the remote control

at the player. Press and hold the ENTER button for 5 seconds. The

player will start using the new remote code.

Cautions
• Never drop the remote control or expose it to moisture.
• Never expose the infrared remote sensor on the front panel to

direct sunlight or other strong light sources.

• Remote may not operate consistently when batteries become low.

Replace them if operation deteriorates.

• If the remote control will not be used for a long time, please

remove the batteries.

• Use the batteries correctly to avoid possible leakage and corrosion.

Do not leave the batteries exposed to direct sunlight or high-
temperature environment for a long period of time. Do not heat
or expose to flame. Do not mix old and new batteries. Do not use
batteries of different types at the same time. Do not attempt to
recharge the batteries.

• In case battery leakage occurs, do not touch the liquid with bare

hands. Wipe out any liquid inside the battery compartment, and
insert new batteries.

Installation

Remote Code Switch

Battery Compartment