Inova PD00941013.001 User Manual
©2004 Inova Computers GmbH
Page D-6
ICP-P4/PM/CM Appendix-D
IPM-ATA
Appendix D
D1.4 IPM-ATA-PCMCIA
The IPM-ATA-PCMCIA has provision for one standard ATA PCMCIA device and one Compact
FLASH or MicroDrive site. Figure D1.4 illustrates the significant connectors for this device while
Table D1.4 indicates the jumper settings for the various Master/Slave device configurations.
FLASH or MicroDrive site. Figure D1.4 illustrates the significant connectors for this device while
Table D1.4 indicates the jumper settings for the various Master/Slave device configurations.
Figure D1.4 IPM-ATA-PCMCIA Board Layout
1
2
3
Table D1.4 IPM-ATA-PCMCIA Jumper Description
It should be noted that the secondary IDE channel only (from rear I/O) is available for use by the
IPM-ATA-PCMCIA (the primary is on the CPU board itself). Multi Master or multi Slave configura-
tions are not supported and will not work!
IPM-ATA-PCMCIA (the primary is on the CPU board itself). Multi Master or multi Slave configura-
tions are not supported and will not work!
Note:
The PCMCIA device cannot and must
not be removed during use. To ex-
change or remove the device, first
power-down the system!
Jumper J8
Jumper J6
2-3
2-3
Open
Open
CompactFlash
or MicroDrive in J3
Master
Slave
Master
Slave
PCMCIA Device in J5