Intel Model Vehicle MPRTM0020 User Manual
Intel NetStructure
®
MPRTM0020 Technical Product Specification
– April 2006
19
Module Components
4.3.4
SAS Connector Interface
One x4 SAS (Serial Attached SCSI) connector is present on the RTM. When the MPRTM0020 is
connected to a MPCBL0020 Single Board Computer, only three of the four high-speed serial
interfaces is available on the SAS connector, because one port is already used for the on-board
local SAS drive on the SBC. The remaining three ports are available as ports 0-2 on the SAS
connector (as shown in
connected to a MPCBL0020 Single Board Computer, only three of the four high-speed serial
interfaces is available on the SAS connector, because one port is already used for the on-board
local SAS drive on the SBC. The remaining three ports are available as ports 0-2 on the SAS
connector (as shown in
) to enable users to connect to a SAS JBOD for remote
storage purposes.
shows the outline of the SAS connector and
provides pinout
information for the connector.
Refer to the Intel NetStructure® MPCBL0020 Single Board Computer Compatibility Report for
information on specific SAS cable and SAS JBOD models that have been tested and validated by
Intel.
information on specific SAS cable and SAS JBOD models that have been tested and validated by
Intel.
Figure 9.
RJ-45 Gigabit Ethernet Connector
Table 4.
RJ-45 Ethernet Connector Pinout
Pin
Signal Name
1
MDI0+
2
MDI0–
3
MDI1+
4
MDI2+
5
MDI2–
6
MDI1–
7
MDI3+
8
MDI3–