InSciTek Microsystems Allworx Phone User Manual

Phone Guide

300 Main Street • East Rochester, NY 14445 • Toll Free 1-866-ALLWORX • 585-421-3850 • www.allworx.com

trademarks or registered trademarks of their respective owners.

Revised: March 28, 2007

Page 24

i. Enabled

(Default)

ii. Disabled

b. VLAN – Allows the phone to stay on the same network without any hardware reconfiguration.

i. Enabled

ii. Hub Debug Mode (Default)

iii. Disabled

c. Remote Plug ‘n’ Play – Key used to set up a remote phone. See the System Administrator.

d. Edit Time Server IP – Option to change the Time Server the phone is logged into.

e. Edit Boot Server IP – The WAN IP address the server is using for the setup of a remote phone.

f. Edit Phone Server IP – Option will appear if DHCP is disabled. Allows the manual entry of the

phone’s IP.

g. Edit Netmask IP – Option will appear if DHCP is disabled. Allows the manual entry of the

Netmask IP.

h. Edit Gateway IP – Option will appear if DHCP is disabled. Allows the manual entry of the

Gateway IP.

i. Phone VLAN Settings – Option will appear if VLAN is enabled.

i. Enter VLAN ID – 2 (Default)

ii. Enter VLAN Priority – 7 (Default)

j. PC VLAN Settings – Option will appear if VLAN is enabled.

i. Enter VLAN ID – 1 (Default)

ii. Enter VLAN Priority – 0 (Default)

4. Select

the

EXIT soft key.

5. Select

the

YES soft key to save any changes OR select NO to cancel changes made.

7.8 Current Status / Info

1. Select

the

CONFIG soft key.

2. Highlight

Current Status/Info.

3. Press

the

Select button.

4. The following information is listed:

•  DHCP Lease Time (if DHCP is enabled)
•  SNTP Time Server IP
•  Boot Server IP
•  Phone IP