HP 20-Feb User Manual
92 Configuring the Library
Chapter 3
Enabling and Changing the Password
Note
Administration procedures can be password protected. These
procedures include: diagnostic tests, configurations, online drive
repair, and setting the date and time. A password is also
required for administration through the remote management
card.
When the library is first installed, the password is inactive. To protect the
system from unauthorized access, use the following procedure to set a
password.
1. Enter
1. Enter
the
Password
menu. A status screen will indicate if a password is
enabled.
— If the password is turned off, select
— If the password is turned off, select
Set New Password
to enable the
password.
— If the password is turned on, select
Change Password
to enter the new
password. It must be exactly eight digits.
— If the password is turned on, select
Turn Password Off
to clear the
password.
Note
If you enter more than eight digits, the ninth digit will become
the first digit of the new password.
2. Select
[OK]
to exit.
Caution
Be sure to document the password. If you forget the password,
contact your service representative.
Main Menu -> Administration -> Change Configuration -> Password