Home Automation OmniPro II User Manual
Encryption Key
Encryption and decryption of data between the OmniPro II controller and the connected device is based on the Advanced
Encryption Standard (AES) using a 128-bit cryptographic key. A unique encryption key is randomly assigned to each OmniPro II
controller at the factory (no records of these keys are kept at the factory). It may be left the same (recommended) or it may be
changed as desired. To view and assign the encryption key, from the previous Setup item (PORT NUMBER), press the down
arrow key (
Encryption and decryption of data between the OmniPro II controller and the connected device is based on the Advanced
Encryption Standard (AES) using a 128-bit cryptographic key. A unique encryption key is randomly assigned to each OmniPro II
controller at the factory (no records of these keys are kept at the factory). It may be left the same (recommended) or it may be
changed as desired. To view and assign the encryption key, from the previous Setup item (PORT NUMBER), press the down
arrow key (
↓
).
ENCRYPTION KEY PT 1:
6F-1B-26-A2-FF-D9-E4-12
This key consists of 16 bytes (that is 16 2-digit values from 0-9 and/or the letters A-F). It is entered into the controller in two
parts (PT 1 and PT 2) consisting of 8 bytes each. Enter the 2 digit value. To enter the digits A-F, first press the “OFF” key, then
press the 0-5 key respectively (i.e. A1 = OFF 0 1 and CB = OFF 2 OFF 1). After the last digit (16
th
digit) has been entered, press
the “#” key to store “PT 1” of the encryption key. Press the down arrow key (
↓
) to enter “PT 2” of the encryption key.
ENCRYPTION KEY PT 2:
DC-67-48-8F-D1-3A-EF-70
↑
After the last digit (16
th
digit) has been entered, press the “#” key to store “PT 2” of the encryption key.
Set Up Names
The system can be set up to display descriptive names such as "FRONT DOOR", "JOHN'S BEDROOM", or "PORCH LIGHT"
for zones, units, buttons, codes, temperatures, areas, and messages. These names are displayed instead of the unit, zone, button,
code, temperature, area, and message number that is normally displayed. Zone and Message names may be up to 15 characters
long. Each of the other names may be up to 12 characters long.
To enter the Set Up Names menu, from the Setup menu, press the 7 (NAME) key.
SET
UP
NAME
1=CTRL 2=ZONE 3=BTTN
↓
4=CODE 5=TEMP 6=AREA
8=MSG
↑
The 6 (AREA) choice will only be displayed if area arming is being used.
Select the item that you would like to name by pressing one of the keys (1-6, and 8). The current name for the first item (unit,
zone, button, code, temperature, area, and message) is then displayed. Use the arrow keys to scroll through the list of names.
To enter a name, enter the two digit code shown in Appendix B for each character in the name, then press the ' # ' key. Use the up
arrow key to delete the most recently entered character.
ZONE 1:
00-95
↓
ZONE 1: FRONT DOOR------
00-95
↑
=DEL
ZONE 1: FRONT DOOR
00-95
↓
Page 79