Home Automation OmniPro II User Manual

 

 

 

 
Notice: The Industry Canada label identifies certified equipment.  This certification means that the equipment meets 
certain telecommunications network protective, operational and safety requirements.  The Industry Canada does not 
guarantee the equipment will operate to the user's satisfaction. 
 
Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of the local 
telecommunications company.  The equipment must also be installed using an acceptable method of connection.  In some 
cases, the company's inside wiring associated with a single line individual service may be extended by means of a certified 
connector assembly (telephone extension cord).  The customer should be aware that compliance with the above conditions 
may not prevent degradation of service in some situations. 
 
Repairs to certified equipment should be made by an authorized Canadian maintenance facility designated by the supplier.  Any 
repairs or alterations made by the user to this equipment, or equipment malfunctions, may give the telecommunications 
company cause to request the user to disconnect the equipment. 
 
Users should ensure for their own protection that the electrical ground connections of the power utility, telephone lines 
and internal metallic water pipe system, if present, are connected together.  This precaution may be particularly 
important in rural areas. 
 
Caution:  Users should not attempt to make such connections themselves, but should contact the appropriate electric inspection 
authority, or electrician, as appropriate. 
 
Notice: The Ringer Equivalence Number (REN) assigned to each terminal device provides an indication of the maximum 
number of terminals allowed to be connected to a telephone interface.  The termination on an interface may consist of any 
combination of devices subject only to the requirement that the sum of the Ringer Equivalence Numbers of all the devices does 
not exceed 5. 
 
This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus set out in the Radio 
Interference Regulations of the Canadian Department of Communications. 
 
Le present appareil numerique n'emet pas de bruits radioelectriques depassant les limites applicables aux appareils numeriques de 
la class B prescrites dans le Reglement sur le brouillage radioelectrique edicte par le ministere des Communications du Canada. 
 
 
IF YOU HAVE TROUBLE WITH YOUR PHONES 
 
...and you suspect that your OmniPro II is causing the trouble, disconnect the Controller from the phone lines by removing the 
PHONE LINE cable from BOTH THE PROCESSOR BOARD AND THE RJ31X JACK INSIDE THE CONTROLLER 
ENCLOSURE.