Honeywell Work Light DR4300 User Manual

Using the BLANK function, the display can be set to turn off a configured number of seconds after the last 
press of any key. Pressing any key while the display is blank will restore it.  

When the TOGGLE function is enabled, the pen currently driving the display will switch control to the 
other pen after a configured timeout period. If the other pen has its TOGGLE function enabled, it will 
switch back after its configured timeout period. 

 

Table 4-17 lists the function prompt in the lock out set up group. 

For a 2-pen recorder, the desired input channel is displayed on the left side of the operator interface. Press 

FUNC  to select channel. 

Press SETUP  key until “DSPLAY” appears in the lower display. 

Press FUNC  key to select the parameter. 

 

OFF [factory setting] 
2s 
4s 
. 
. 
. 
30s 

—Use this parameter to set 

timeout period after which the display goes blank. OFF 
disables the function. 

OFF [factory setting] 
2s 
4s 
. 
. 
. 
30s 

—Use this parameter to set the 

timeout period after which control the display is passed to 
the other board (pen).