Hampton Direct H200 User Manual

Hampton H200 Cast Freestanding Woodstove

25

The bracketry should start from the highest point, 
as seen below. If needed, bring the bracketry 
down 1/16" each time, until fi nding the best 
locking position. The door latch will catch best 
in this way. 

(Listen for a double click sound when the door 
is locked). 

1)  Remove handle (front or side) by undoing 

the hex head bolt using a 7/16" socket 
wrench.

2)  Fit new door handle over latch and se-

cure.

 

Assembly shown below.

The door bracketry may require adjustment as 
the door gasket material compresses after a few 
fi res.  Removal of the spacer washer will allow 
the latch to be moved closer to the door frame, 
causing a tighter seal. 

Relocate the washer removed from the back 
of the bracket to the front. This will allow the 
same screw to be used. 

Use the 3/16" allen key enclosed in the packaged 
manual to make this adjustment.

If the front door gasket requires replacement 
5/8" diameter material must be used. Hampton 
uses a 5/8" diameter gasket (Part# 936-232). 
A proper high temperature gasket adhesive is 
required.  See your Hampton Dealer.