Glowworm Lighting 300 I User Manual

4

In your own interests and that of safety, it is the LAW that this 

product is installed by a 

competent person in accordance 

with the current issue of these regulations.

Under Section 6 of The Health and Safety at Work Act 

974, we are required to provide information on substances 

hazardous to health. 
The adhesives and sealants used in this product are cured 

and give no known hazard in this state.

With regards to the “Manual Handling Operations, 99 

Regulations”, the appliance exceeds the recommended 

weight for a one man lift.

The product MUST be earthed.

All system components shall be of an approved type and all 

wiring to current I.E.E. wiring regulations.
External wiring must be correctly earthed, polarised and in 

accordance with the relevant standards.
In GB, this is BS 767.
In IE, this is the current edition of ETCI rules.

The product MUST be connected to a permanent 30V ac, 

50Hz supply.
Connection of the whole electrical system of the product, 

including any heating controls, to the electrical supply MUST 

be through one common isolator and must be fused 3 Amp 

maximum.
Isolation should be by a double pole switched fused spur box, 

with a minimum gap of 3mm for both poles.  The fused spur 

box should be readily accessible and preferably adjacent to 

the product. It should be identified as to its use.
Alternatively connection can be made through an unswitched 

shuttered socket and 3A fused 3-pin plug both to the current 

issue of BS 363, provided they are not used in a room 

containing a bath or shower.
Wiring to the product must be PVC 85°C insulated cable, not 

less than 0.75mm (4/0.0mm).

This product is tested and certificated for safety and 

performance. It is, therefore, important that no alteration is 

made to the product, without permission, in writing, by Glow-

worm.
Any alteration not approved by Glow-worm, could invalidate 

the certification, warranty and may also infringe the current 

issue of the statutory requirements.

The CE mark on the Fluropro solar control indicates that 

it complies with the basic requirements of the applicable 

directives as stated on the data badge.

Glow-worm support the Benchmark initiative. It is very 

important that the service record is completed by the 

installation engineer and handed over to the user.