GE X-9 User Manual

The two signals that are controlled by the cross-fader 
are known as 

 and 

.

You can set these to be any of the following using the 

 and 

 controls below and to the 

right and left of the program faders:

Programs 1 through 4, a sam-
pler (

 for A, and 

 for B) or 

.

The 

 setting is equivalent 

to OFF. In other words, if either 

the 

 or the 

 control is set to 

, no signal is assigned to go through the cross-

fader on that side, and moving the cross-fader to the 
side with the 

 setting has no effect on that side. 

When 

 is selected, use the appropriate program 

fader(s) and the master fader.

Move the fader from the left (fully A signal only) to 
the right (fully B signal only) to perform the cross-
fade between the two signals.

The signal flow is therefore:

Note that this is SAMP1 
for the ASSIGN A control

Incoming signals are 
assigned to programs

Programs (and samplers) 
are assigned to the 
cross-fader A and B 
signals

Programs (and 
samplers not 
assigned to the 
cross-fader) go 
straight to the 
master, together 
with the mic

The cross-fader 
determines the A and B 
levels sent to the master

The master outputs 
(what your audience 
hears)