First Act FI3002 Instruction Manual

Congratulations on your new electronic guitar!
Please read this guide carefully before you begin playing.

FI3002

 

INSTRUCTION MANUAL

customer assistance
Phone: 888.551.1115
Email: info@firstact.com

First Act, First Act Discovery, and the 
First Act Discovery logo are trademarks 
of First Act Inc.
©2008 First Act Inc.
All rights reserved.
FI3002.M.01

Batteries required:  3 x “AA” size (not included)  

1. Open the battery compartment cover, position the batteries in the 

compartment and make sure that (+) & (-) are in the correct position. 

2. To ensure proper safety and operation, batteries must always be 

replaced by an adult. Never let a child use this product unless the 

battery door is secured.

3. Keep batteries away from small children. Immediately and safely 

dispose of all used batteries. 

1. Do not mix old and new batteries.

2. Do not mix alkaline, standard (carbon zinc) or rechargeable (Nickel     

    – Cadmium) batteries.

3. Only the same or equivalent types of batteries are recommended.

4. Non rechargeable batteries are not to be recharged.

5. Rechargeable batteries are to be removed from the product before 

    being charged. 

6. Rechargeable batteries are only to be charged under adult 

    supervision. 

7. Exhausted batteries are to be removed from the product.

To activate guitar, press any of the rhythm keys or the demo key.

Press the demo key to hear one of the 4 rhythms (rock 1, jazz 1, rock 2, 

jazz 2). Press the demo key again to switch to the next rhythm.

Do not cover the infrared control, or the rhythm will be interrupted.

Press any of the rhythm keys to play one of 4 rhythms (Rock 1, Jazz 1, 

Rock 2, Jazz 2).

Press and hold down the T1, T2, or T3 keys to change to a different 

tempo while you’re playing a rhythm.  

The reset key stops the rhythm or demo. 

To play the rhythm by infrared control, activate the guitar, then wave 

your hand like you are strumming in the center of the guitar between 

the two red lights. Each time you strum, some notes will play. Keep 

strumming to play the whole rhythm!

Turn the volume dial to control the music volume.

Press the whammy bar downward to play a whammy lick.

1.    Read and follow these instructions.

2.    Do not use this device near water.

3.    Clean only with a dry cloth.

4.    Do not use near any heat sources such as radiators, heaters, 

 

or stoves.

5.    Only use the attachments/accessories specified by the  

 

manufacturer.

6.    Refer all servicing to qualified service personnel. Servicing is

 

required when the drum pad has been damaged in any way, liquid 

 

has been spilled onto the drum pad, the drum pad has been   

 

exposed to rain or moisture, does not operate normally, or has  

 

been dropped.

1.  Do not change the parts without professional instructions. Any  

 

change may cause malfunctions.

2.  When the guitar is not in use for a long period of time, remove  

        the batteries to avoid battery corrosion.
3.  Keep the wrapping bag out of the reach of children to avoid a  

 

choking hazard.

4.  Always move the guitar carefully to avoid damage to outer   

 

covering and inner components.

5.  The guitar should not come in contact with acid or alkali. It  

 

should not be operated where there is corrosive or excessively  

 

moist air around to avoid corrosion of the electrical contacts.

note: This equipment has been tested and found to comply with 

the limits for a Class B digital device, pursuant to Part 15 of the FCC 

Rules. These limits are designed to provide reasonable protection 

against harmful interference in a residential installation. This 

equipment generates, uses, and can radiate radio frequency energy 

and, if not installed and used in accordance with the instructions, 

may cause harmful interference to radio communications. However, 

there is no guarantee that interference will not occur in a particular 

installation. If this equipment does cause harmful interference to 

radio or television reception, which can be determined by turning the 

equipment off and on, the user is encouraged to try to correct the 

interference by one or more of the following measures:
-      Reorient or relocate the receiving antenna.
-      Increase the separation between the equipment and receiver.
-      Connect the equipment into an outlet or a circuit different   

 

from that to which the receiver is connected.

-      Consult the dealer or an experienced radio TV technician 

 

for help.

Warning: Changes or modifications to this unit not expressly approved 

by the party responsible for compliance could void the user’s authority 

to operate the equipment.