Cateye HL-EL600RC Leaflet

Page of 1
CATEYE SINGLE SHOT
HL-EL600RC
Pat. and Design Pat. Pending 
Copyright© 2007 CATEYE Co., Ltd.
EL60RC-070620   066640130  1
LIMITED WARRANTY 
2-year Warranty: Light unit / Battery charger
(Deterioration of the battery is excluded.)
CatEye products are warranted to be free of defects from materials and workmanship for a period of 2 years from original 
purchase. If the product fails to work due to normal use, CatEye will repair or replace the defect at no charge. Service must 
be performed by CatEye or an authorized retailer. To return the product, pack it carefully and enclose the warranty certifi cate 
(proof or purchase) with instruction for repair. Please write or type your name and address clearly on the warranty certifi cate. 
Insurance, handling and transportation charges to CatEye shall be borne by person desiring service.
For UK and REPUBLIC OF IRELAND consumers, please return to the place of purchase. This does not affect your statutory rights.
*1
Dial
Screw
Release button
Bracket rubber pad
Bracket
Bracket strap
Light unit
2
3
4
6
ON
OFF
Hi
Low
Flash
2 sec.
Double press
Double press
Switch
Charge jack
Battery charger
To AC power outlet
Battery indicator
1
2
Charging Indicator
x1
Screw
Lens unit
Battery
Battery connector
Body
Rubber packing
2
3
OK
NO!
Left side
Battry guide
#533-8827
H34 Bracket
#534-1859
NiMH 4.8v 780mAH
UL:#534-1860 
UK:#534-1861
EC:#534-1862 
AS:#534-1864
CHR-780mAH 4.8v NiMH
SPARE PARTS
ENG
COMPONENTS
Light unit
H34 Bracket
Battery charger
 FOR SAFE OPERATION
Do not place it within children's reach.
In preparation for unexpected battery shutoff, we recommend you carry a dry-cell 
battery light unit with you.
If the light unit or parts become dirty with mud, etc., clean with a soft cloth which is 
moistened with mild soap. Never apply paint thinner, benzine or alcohol; damage 
will result.
Mount  the  light  unit  more  than  10  cm  away  from  the  wireless  meter.  When  it  is 
mounted too close, the transmission may be affected adversely.
This product has waterproof features that allow you to use it in rain. Do not use it 
soaked in water.
  Before Initial Use
Before shipment, it is charged enough to check the light. Be sure to charge it before use, 
according to the instructions "How to charge."
INTRODUCTION 
 Before using the light, please read this manual and the attached “NiMh 
Batteries” thoroughly, and keep them for future reference.
Thank  you  very  much  for  purchasing  the  CATEYE  "SINGLE  SHOT  HL-EL600RC."  This 
product is a high power rechargeable light unit that integrates a high power LED and a 
nickel metal-hydride rechargeable battery into a compact body.
HOW TO MOUNT
Wrap the bracket strap around the 
handlebar, and put it in the dial.
Securely tighten the strap by turn-
ing the dial.
Cut  off  the  excess  bracket  strap 
extending from the dial.
I n s e r t   t h e   l i g h t   u n i t   t o 
the  bracket  until  it  clicks.
To remove, pull out while pressing 
the release button.
CAUTION!:
Make  sure  to  tighten  the  dial  by 
hand.  If  you  tighten  it  too  hard 
with a tool, the screw threads may 
be stripped.
When the angle adjustment on the 
right and left sides is loose, tighten 
the screw (
*1
).
Round  off  the  cut  edge  of  the 
bracket strap to prevent injury.
How to Adjust Beam Angle
Slightly  loosen  the  dial  on  the 
bracket.
Adjust the light unit angle so that 
the light is not directed to oncom-
ing cars.
When the dial is too fi rm to loosen, wash it 
slightly with water to loosen it.
Do not loosen the dial too much, or the bracket 
strap may come off. Loosen the dial just enough 
to allow the bracket to move slightly. Securely 
tighten the dial after adjusting the strap.
It can also be adjusted 10 degrees to the left 
and right.
1�
2�
3�
4�
5�
6�
*
*
*
3
 How to charge
Open the charge jack cover at the 
back of the light unit to connect the 
battery charger plug.
Plug  the  battery  charger  to  an 
AC outlet.
After  charging,  remove  the  plug 
and close the charge jack cover.
1�
2�
3�
HOW TO REPLACE BATTERY
HOW TO USE
1
 Lighting (lighting pattern selection)
The lighting pattern is selected using a switch.
Standard charg-
ing time
Blinking red light : Charging
Green light 
: Charging is completed
Approx. 5 hours
Charging indicator state
Be  sure  to  use  the  special  purpose  battery 
charger.
Charging and lighting times are approximate 
values,  and  will  vary  by  environmental  and 
user conditions. 
*
*
ON 
 OFF : Long press
Hi 
 Low  : Single press
Flash 
: Quick double press
Hi 
: About 2 hours
Low  : About 6 hours
Flash : About 24 hours
Switch
Standard continu-
ous lighting time
2
 Remaining battery capacity
When the battery indicator lights up red, the bat-
tery is almost shutoff. Charge the battery as soon 
as possible.
Remove 2 screws at the front of 
the  lens  using  a  2.5  mm  Allen 
wrench.
Slowly pull out the lens unit from 
the body.
Remove the battery connector con-
nected to the board, and replace it 
with a new battery.
Place the battery on the tray, and 
insert it to the body in place, and 
secure it with 2 screws.
CAUTION!:
The  lens  unit  is  a  precision  part; 
therefore,  never  disassemble 
it.  Otherwise,  the  optimum  light 
distribution may be lost.
To maintain its waterproof features, 
assemble the lens unit with a rubber 
packing-sheet correctly.
In  order  to  avoid  cable  damage, 
when  re-assembling  the  light, 
make  sure  the  battery  cable  is 
routed inside the battery guide as 
shown below.
1�
2�
3�
4�
SPECIFICATIONS
Light source 
High power white LED x 1
Battery 
NiMH 4.8v 780mAH
Battery charger  CHR-780mAH 4.8v NiMH
Operating time  Hi 
: Approx. 2 hours
Low  :  Approx. 6 hours
 
Flash  : Approx. 24 hours
Standard charging time
Approx. 5 hours
Temperature range  Charging  : 32˚F – 104˚F (0˚C – 40˚C) 
Operating : 5˚F – 113˚F (-15˚C – 45˚C)
Recharge/discharge number of times
About 300 times (until the rated capacity drops to 50%)
Dimensions/weight 3-17/64” x 2-23/64” x 1-1/2” (83 x 60 x 38 mm) /  4.09 
oz  (116 g)
The specifi cations and design are subject to change without notice.
*
Service & Research Address for USA
CATEYE Service and Research Center 1705 14th St. 115 Boulder, CO 80302
Phone : 303.443.4595  Toll Free : 800.5CATEYE 
Fax : 303.473.0006 
E-mail : service@cateye.com 
URL : http://www.cateye.com
CO.,LTD.
2-8-25, Kuwazu, Higashi Sumiyoshi-ku, Osaka 546-0041 Japan
Attn : CATEYE Customer Service Section  Phone : (06)6719-6863  Fax : (06)6719-6033  E-mail : support@cateye.co.jp  URL : http://www.cateye.co.jp