Atmel SpaceWire Router SpW-10X User Manual
Ref.: UoD_SpW-10X_
UserManual
Issue: 3.4
SpW-10X
SpaceWire Router
User Manual
Date: 11
th
July 2008
Preliminary
103
9. REGISTER DEFINITIONS
This section describes the internal configuration registers of the SpW-10X Router.
The following subsections contain register bit description tables which hold the following information:
• The bit numbers of each field
• A descriptive name for each field
• The reset value for each field
• A description of what the each field in the register is used for
• An indication of whether the field is readable and/or writeable by a configuration command.
The internal register size is 32 bits unless otherwise specified in the register description. There are
263 registers in the configuration port addresses. Registers that are shorter than 32-bits or that have
unused fields will return zero in all the unused bit positions when read. The unused bit positions are
ignored during writing but should in any case be set to zero.
263 registers in the configuration port addresses. Registers that are shorter than 32-bits or that have
unused fields will return zero in all the unused bit positions when read. The unused bit positions are
ignored during writing but should in any case be set to zero.
9.1 INTERNAL MEMORY MAP
The memory map for the SpaceWire Router is shown in Figure 9-1.
GROUP ADAPTIVE
ROUTING TABLE
REGISTERS
PORT
CONTROL/STATUS
REGISTERS
ROUTER
CONTROL/STATUS
REGISTERS
Address bit-8 = 0
Address bit-8 = 1
255
32
31
0
255
0
Figure 9-1 Router Internal Memory Map
The Group Adaptive Routing (GAR) registers map SpaceWire logical addresses 32-255 to the
physical ports – SpaceWire ports or External ports. The link control/status registers are used to
configure the ports and router functions and to report status information. The router control/status
physical ports – SpaceWire ports or External ports. The link control/status registers are used to
configure the ports and router functions and to report status information. The router control/status