Atmel SpaceWire Router SpW-10X User Manual

Ref.:   UoD_SpW-10X_ 

 

Issue:  3.4 

  

 

Date:  11

 

 

121

 

0 Configuration 

Port 

Error Active 

‘0’ 

Indicates that the Error Active bit in the 
configuration port is asserted. 

A write to this register with bit 0 set will clear all 
the error flags in the configuration port 
control/status register. 

R/W 

30:1 SpaceWire 

and 

External Port Error 
Active 

All bits 
set to 
zero 

Indicates that the Error Active bit in the 
corresponding number SpaceWire or External 
port is asserted. 

A write to this register with one or more of 
these bits set will clear all the error flags in the 
corresponding SpaceWire and External port 
control/status registers. 

When writing to this register with all bits set all 
error flags in all port control/status registers are 
cleared. 

Note: only bits 10:1 are used in the SpW-10X 
router. 

R/W 

31 

Not used 

All bits 
set to 
zero 

Not used because there are a maximum of 30 
SpaceWire / External ports supported by the 
router design. 

R 

 

9.5.5 Time-Code Register 

The time-code register address is 260 (0x0000 0104). 

The time-code register contains the current value of the internal time-code register.  Its fields are 
shown in Figure 9-7 and described in Table 9-12. 

Time value

31

Time-code flags

7 6

0

Not used

5

8