Asante Technologies IC36240 User Manual

 

5.  Type ip address and the new address. The following screen appears: 

Switch> enable 
Switch# configure 
Switch(config)# ip address 192.168.123.254/24 
Switch(config)# end 
Switch# show ip 
Dhcp Client Enabled ..........: No 
IP Address ...................: 192.108.250.51 
Subnet Mask ..................: 255.255.255.0 
Default Gateway ..............: 192.108.250.5 
HTTP Server ..................: Enabled 
HTTP Port ....................: 80 
Switch# write file 
Writing current-config to startup-config. Please wait. 
Configuration saved to startup-config file 

It is also acceptable to enter the subnet mask by typing ip address 192.168.123.254/24. Use the show 
interface veth1 command from privileged mode to see the new IP address. The new IP address automatically writes 
over the default IP address. 

See Chapter 6 for more information on assigning IP addresses to interfaces. 

To define the default IP gateway for the switch, insert a static route: 

Switch(config)# ip default-gateway 192.168.0.254 

To restore the switch to its factory default settings, follow the commands shown in the following screen. 

Switch> enable 
Switch# reload ? 
  fac-dflt-except-IP  Reset ALL system parameters except IP parameters to factory 
                      default 
  factory-default     Reset ALL system parameters to factory default 
  <cr>

 

The switch is ready for configuration. Refer to the following chapters for management and configuration information. 

The IntraCore IC36240 has two boot banks to store its runtime code. You can select which bank to use for the next 
boot with the following command: 

Switch(config)# boot system flash {bank1|bank2} 

23 

Asante IntraCore IC36240 

User’s Manual