APC AP9810 User Manual
12
Dry Contact I/O SmartSlot Card
Installation steps
Warning: After installation, it is strongly recommended that you
fully test your configuration before putting it into a production
environment.
fully test your configuration before putting it into a production
environment.
1. Make all connections to the Dry Contact I/O SmartSlot Card to support
your configuration before continuing. See “Itemizing the input contact
and output relay terminal blocks” on page 6 for information on making
the connections.
and output relay terminal blocks” on page 6 for information on making
the connections.
Electrostatic discharge: The Dry Contact I/O SmartSlot
Card is sensitive to static electricity. Handle the Card by the
end plate only. Do not touch the exposed printed circuit
board.
Card is sensitive to static electricity. Handle the Card by the
end plate only. Do not touch the exposed printed circuit
board.
2. Use a #2 Phillips-head screwdriver to remove the two screws retaining
the slot cover on the host device. Keep the screws for use later. Keep the
slot cover for future use.
slot cover for future use.