American Dish Service Vision C3 User Manual

Function:

reports all RF tracking parameters for primary &

secondary satellites*

Command:

Response:

F,x,fffff,S,C,ID,P,B,D <cr>

Where:

x =  Satellite (a = Primary, b = Secondary)
fffff = Frequency in MHz (00000 and 10700 to 

12700)

S =  Symbol rate in Mbit/Sec (1000 to 29999)
C =  FEC code rate (valid rates = 12, 23, 34, 56, 

67, 78)

ID =  Satellite Network ID in hexidecimal format 

(valid range = 0x0000 to 0xffff hex)

P =  LNB Polarization (v = vertical, h = horizontal, 

r = right, l = left)

B =  the LNB down conversion frequency (l = low, 

h = high, u=USA)

D =  decoding type (0 = test, 1 = DSS-A, 

2 = DSS-B, 3 = DVB)

* This command dumps all eight combinations of the Satellite/
Freq/Sym/FEC/ID/POL/Band/Decode currently stored in RAM.

Function:

sets RF tracking parameter

Command:

Response:

Echoes the input data

Where:

@SATCONFIG = directs data to the RF Board

X =  satellite location A or B

N =  satellite table # (98 & 99 are slots for user-

configured satellites)

F =  frequency in MHz (either 00000 or a range   

from 10700 - 12700)

S =  the satellite transponder symbol rate in 

Mbit/second (01000 - 29999)

C =  the FEC code (e.g., 12, 23, 34, 56, 67, 78)

ID = the satellite network ID in hexidecimal format 

(0x####)

P =

the LNB polarization (v = vertical, 
h = horizontal, r = right, l = left)

B =  the LNB down conversion frequency (l = low, 

h = high, u = US)

D =  decoding type (0 = test, 1 = DSS-A, 

2 = DSS-B, 3=DVB)